Exmark Quest Won't Start. Blown Fuse

[@morales1ist]

Thanks for the info! Got my Lazer Z up and running.

[@wayneharley3351]

Buddy thanks for the info. This saved me a lot of money and time!

[@joshreed1933]

Bro, you saved me so much dang hassle. Thanks buddy!

[@MrBillybob57]

I just bought from a guy the very same exmark Quest and learning about the maintenance and this helped but mine still not cranking . It was cranking fine until the other day while cutting I stopped to move something in the way . I stopped the blades and when I pulled up the brake handle it shut off and came back and wouldn't start back up . the battery test fine and changed fusses . still trouble shooting .

[@cheapjoker3321]

@@MrBillybob57 I would make sure you check all the safety switches to make sure none of them have become non operational. Assuming there is one associated with the brake handle too.

[@kellyhicks3626]

Thanks it worked

[@2SD251Jim]

That mower looks trashed....you got your money out of it

[@saneegottze6618]

Appreciate it!

[@joshcantu6659]

This was helpful but now every time I engage the PYO switch that fuse blows…any ideas? Harness at the PTO has power and PTO switch will turn it on/off.

[@cheapjoker3321]

I am not sure on that.

[@johnyesko5322]

Pto clutch is bad most likely shorted, remove it get the part number and google it, cheaper that way

[@johndemmink3539]

Did you ever figure out what caused the fuse to blow? I’m having the exact same issue. I replaced the pro clutch figuring it was shorted but same result. At the bottom of the fuse block there is a spade type diode. Mine tested bad, I replaced it, the blades engaged for about three seconds then it blew the fuse and ruined the diode again. I now pulled that diode out, replaced the blown fuse and the blades are working. However I still don’t know what the hell is going on.

[@vikwillwin]

Pleaae invest in a cheap power washer . Have a great day

[@ralph5450]

If not, at least a hose.

[@ToryaJohnson-ny4tl]

I'm trying to trace wires in the harness