Get stuck with the wheel loader and drive on two wheels when I'm trying to pick up a big log I'm going to saw. I use Logosol BigMill with Stihl MS881 to saw really big logs. On the saw there is 167cm/66inc bar
Пікірлер: 14
@westyaus50903 ай бұрын
That was a very simple and great video thank you. Ill search your uploads for a vid with the ms661. Westy from South Australia, Australia 🇦🇺
@rorylobban4789 Жыл бұрын
The panther mill we get in the uk is worth a look mate.
@Projectoftheday Жыл бұрын
I will see if I can get hold off on
@Wedget Жыл бұрын
Gday mate, I run a 84" Granberg Alaskan mill with a 84" GB cutter bar , I also use a 10 degree 5 skip tooth chain coupled to my stihl 880, for what I do cutting slabs up to 1850mm wide this is the most cost effective way to process my timber albeit more labour intensive, thanks for sharing your video
@roughhewnuk Жыл бұрын
👍👍👍🌳🌳🌳🌳🌳🌳🌳
@peter_kelly Жыл бұрын
Invest in a spud and remove as much of the bark as you can prior to milling. Takes a few extra minutes but your chain will stay sharp for much longer.
@Projectoftheday Жыл бұрын
Thanks
@stijnw5506 Жыл бұрын
Very nice sawmill. There is something I miss in every demo video and that's how during the installation of the first cut, the second bracket is leveled with the first bracket. How much time does it take to install the sawmill for the first cut?
@Projectoftheday Жыл бұрын
It normally take 5-10 min for the first cut. 30 seconds between cut I think
@torstenbengtsson5998 Жыл бұрын
Har bara kört med alaskan mill, men den där såg riktig smidig ut. Gör som du, måttar och utgår från centrum i båda ändar. Men tycker du det har någon betydelse var sen sågsnittet hamnar? Om du är med hur jag menar, om mittenplankan får kärnan var det nu än hamnar. Eller om det är bättre att försöka måtta från centrum och få sågsnittet rakt i märgen.
@Projectoftheday Жыл бұрын
Efter som en stock sällan är helt rak. Försöker man då klyva kärnan, kommer man pricka den i änden där man börjar och slutar snittet. Sedan inne i stocken kommer den troligen vandra upp och ned lite granna med risk att man får den i båda skivorna. Jag brukar försöka centrera kärnan i en skiva så den kan vandra lite upp o ner men fortfarande bara stanna i en skiva. Sedan är det dåliga runt kärnan en ca 1,5-2cm cirkel som ger mycket spänning
@alexandertaabli8345 Жыл бұрын
Hello I hope you are doing well I need your contract pls to order some machines from you