EZ COMMAND CONTROL CENTER HOW TO

[@momandsontrainrailfans]

Thank you thank you...yes helped me out alot. Awesome job buddy. You are great 👍

[@engineerpat5290]

You are very welcome. I am glad the video was helpful! Thank you also for the kind words!

[@SkipRoGlo]

I have a small HO Train layout using flex track with drop feeders to a bus wire. I have this EZ command station controller. There are two red wires that connect to your track. I don’t have the EZ track. Can I connect it straight to my bus wire? There are two red wire on the controller are both positive?

[@rodder1938]

Is there a on and off power # when your not using power pack or do you just pull plug ?

[@engineerpat5290]

Just pull the plug.

[@Redheadedlady55]

~I have 6 N-scale running & wanted to know how to get all six on this E-Z Command control center...plz let me know if I bought wrong control. Just have single contols on them now.

[@engineerpat5290]

The N scale DCC locos should have an address of 3. The programming should be the same as I demonstrated in the video.

[@coky5617]

hi. do you know how to use the new ez plus command control?

[@engineerpat5290]

No I do not

[@geneschindler9537]

I got 2 Locos that say dcc ready and I can only run them on analog, with the e-z command what am I doing wrong, I got 3 others that work fine?

[@engineerpat5290]

Hello sir, thank you for commenting. If you have a DCC ready locomotive that is DC they only run in analog mode. I would upgrade them to DCC. You can buy a decoder and have your local train store install one. Once a DCC decoder is installed you can get more out of the engine. Hope this helps.

[@geneschindler9537]

@@engineerpat5290 I got a nother? The 2 new logo's are dcc ready on the boxes, don't they already have decoders, I took cover off and found a 8 pin ,I'm guessing it's a decoder

[@engineerpat5290]

@@geneschindler9537 the DCC decoder that is required is an 8Pin decoder. Digitrax is the brand that I recommend.

[@davidf9630]

DCC ready is just that. Digitrax has an east to use decoder locator on their website they usually run just under $50. For simple decoders. I think they’re great products

[@rorymoore8982]

Does this ez command controller run Thomas and friends engines?

[@engineerpat5290]

if they are dcc then yes it should be good!

[@davidf9630]

Coolio… I like your description… I just went digital with 5 locomotives

[@engineerpat5290]

NICE!