FANUC RoboGuide Tutorial - Getting Started with RoboGuide | Elite Automation

[@Jrjulio95]

Good video Malachi, time to get more training on this thanks for the video

[@EliteAutomation]

No problem. We have some more coming in the next few weeks.

[@nguyentung6862]

I am looking forward to watching your videos about simulation between roboguide and a real robot in real time. Thank you so much,

[@EliteAutomation]

Thank you. Hopefully we will have out soon.

[@nguyentung6862]

@@EliteAutomation have a great day :)

[@ryanwilson1369]

@@EliteAutomation When I got certified years ago at our tech center there was a book that we used to go through lessons like the videos you are creating. Do you happen to know what book that would have been becuase I cant seem to find it anywhere online now.

[@LuisMiguelRosalesAguirre]

Thank you for the video, nice idea to make content! Can you do some videos of welding robots please? I´m new in robots but I´ll like to get deep in it, recently in the workshop obtained a fanuc arcmate and I´ll love to get involved with it. Thanks a lot!

[@hc6133]

Hello Malachi, it is avery resourseful vedio, I am taking help of your videos regularly. But in my case, whatever the programe I write it is going to some intail point which is not in the NC code. What might might be the possible reason. Can you please tell me. My work station is WeldPro using Fanc robot.

[@EliteAutomation]

I'm not quite understanding what condition you are facing. Can you clarify more

[@mohamedchibani5935]

please, can you adjust the volume of the jingle, it's very loud. Thanks for video BTW, keep up

[@EliteAutomation]

The Bell Notification?

[@EliteAutomation]

No Problem! Hope they are valuable!

[@corinamorina5766]

where can i connect, because when i try to use it without the license, and i make the configurations on it, it shows an error that i m not registered and i don't know where to register , please help me

[@EliteAutomation]

You probably can't use without a license

[@FSRIVATSAVND]

Hi, how did you add crx in roboguide?

[@EliteAutomation]

This isn't a CRX it's an LR mate but it should be there if you have the most recent version of roboguide. However being that its collaborative it may not be there.

[@valeriikor8918]

Звук музыки ГОРАЗДО ВЫШЕ чем речь!!!!! Очень неприятно!!!

[@EliteAutomation]

Thank you for the feedback will work on adjusting

[@sainandjadhav8606]

Hi i need help with offset programming can you provide email so that i can share for what purpose i want to program the robot

[@EliteAutomation]

Is it simply a position offset?