Fanuc Welding Robot Programming Circles

[@paikarayakutruka7210]

This video very useful Sir, more video plz

[@bsmylen]

Best video for teaching Circles

[@ibrahimkuru3130]

Thanks a lot, really helpful.

[@jaym2112]

Title is a bit deceiving. There was nothing specific to the welding robot in this video. The program was the same as if it was just handlingtool with a pointer.

[@ataekinci6150]

Hallo, kann ich auch für s420iw-Fanuc gleich programmieren? Danke

[@davidmackey7156]

Would you know how to adjust the position of the torch so that the it follows the same path but is always at a 45 degree angle like would be done when welding a circular part.

[@RiceMFG]

All you would have to do is rotate it into position when teaching. So in each position you just rotate your gun angle to what you want. It will still so a circular movement it will just roll the gun to the angle you taught.

[@TheYavy]

@@RiceMFG you do rotate it with your hands or just on the software again?

[@mjdegn]

@@TheYavy it’s all on the software. You don’t wanna grab the torch and adjust by hand, it would need recalibrated

[@amanmohtta3057]

Osm sir

[@deontedawson4546]

Thank you sir!!!

[@cncmacrosteps2756]

this videos very usfull sir.

[@williamhuang5329]

Hanzhen harmonic drive gear , robot arm gear , joint gear reducer, over 30 years experience

[@toadthree]

At what point would you turn on arc start and arc end?

[@d8l835]

Step 2, instead of j pos. It would be a weld start, last circle point move cursor past the fine term and you will have option to weld end

[@gongetya.9244]

Really wish the Weld Starts and Ends were implemented in this video.

[@d8l835]

Step 2 would change from a j position, to a weld start. At the end of the circle point, where it says fine, move your cursor to the right past the fine term, and you will have the option to add an arc end/or weld end. Everything else would stay the same, if your welding a circle though, you probably dont want any points to be fine EXCEPT your statt and end, the circle points in between should all be CNT

[@maticanu]

@@d8l835🎉

[@mrmen171]

what is the purpose of the first line?

[@ricardocontreras8861]

Home

[@sohitkumar5086]

Hi sir This is my name Mr Sohit Kumar education 10th class 12th diploma mechanical engineer 1 year experience quality in process Haridwar