Great video thanks but where is the crankshaft senor to ??? Is only thing missing
@enkamotors70127 ай бұрын
The crankshaft sensor is located at the back of the engine, under the intake manifold on the engine block
@thezerocool22 Жыл бұрын
brilliant vid, keep it up! Out of interest, can you inspect the chain without removing the cover, for example the plastic cover just above the oil filter housing?
@everybodyneedsadave Жыл бұрын
No you can't
@varunesh1232 жыл бұрын
How much miles did the vehicle run before chain replacement?
@lewisjenkins1114 Жыл бұрын
I did this job today on a Seat Ibiza, the right hand chain guide was completely missing, it was in the bottom of the sump and all stuck in the strainer. And those timeing covers are a pain to get back on 😒
@enkamotors7012 Жыл бұрын
Yes I agree!
@lukemeecham19976 ай бұрын
When your chain gave up did it smash any valves?
@lewisjenkins11146 ай бұрын
@lukemeecham1997 Fortunately the chain hadn't given up, it hs jumped timing slightly on the cams, but no internal engine damage occurred if my memory serves me correct. Most VWAG engines aren't interference engines, meaning it's very unlikely the piston would touch the valves even under complete chain or belt failure 👍🏻
@TuuSaR-so4ez5 ай бұрын
It's a design fault, it will eventually hit, regardless how often the oil has been changed.
@samwilson73578 ай бұрын
Very good thank you for sharing
@Ozkan2106 Жыл бұрын
is it possible to chance just the tensioner alone? just screwing the tensioner from outside , without to disasembly the hole thing?
@enkamotors7012 Жыл бұрын
No, you cannot reach the tensioner without removing the lid but the problem is usually due to the chain stretching so the everything inside must be changed. Hope this helps
@Ozkan2106 Жыл бұрын
@@enkamotors7012 Thanx for the repley!
@everybodyneedsadave6 ай бұрын
No
@lukemeecham19976 ай бұрын
If your chain snaps will I need to replace valves or is this a non interference head?
@enkamotors70126 ай бұрын
Yes, if the chain snaps the valves will need to be replaced.
@jcgenuino92728 ай бұрын
Hi how about bent valves, were u able to check them??
@enkamotors70128 ай бұрын
There was no problem with bent valves as there was no snap or jump. I hope it helps.
@charliediver15602 жыл бұрын
Great vidio , thanks for posting .
@colinbryant55314 ай бұрын
Does the tensioner need a gasket?
@enkamotors70124 ай бұрын
No you don’t need a gasket
@mariusnicolaesima Жыл бұрын
Al meu motor are zgomotul acela la pornirea la rece, dar pornește mai bine decât acesta din videoclip. O să verific lanțul.