FDM 3D Printing Quiz!

[@R3DPrints01]

Cleaned the plate, changed plate type, or added an adhesive

[@SlicePrintRoleplay]

Correct! I changed the bed to one with a smooth PEI sheet. Good guess!

[@andrewlawton4155]

Move the spool of filament off the top of the printer

[@SlicePrintRoleplay]

Not sure if that's q guess or a command. 😂 But I've released some new videos showing the results of my testing with and without the spool on the printer.

[@09167]

The filament

[@SlicePrintRoleplay]

Good guess but no. It was all done with the same filament.

[@86abaile]

Dried the filament.

[@SlicePrintRoleplay]

Haha no, that was the answer to my last quiz. I'm not trying to be a troll. 😂

[@kathleengray106]

Cleaned the extruderhead

[@SlicePrintRoleplay]

Oh that's a good guess but that wasn't the cause of the issue in this case.

[@zac2877]

Washed your hiney clean.

[@SlicePrintRoleplay]

🤣🤣🤣🤣

[@DanielBrandt77]

Cleaned the print bed? With IPA?

[@SlicePrintRoleplay]

Good guess (though I don't personally use IPA for cleaning my beds) but not the cause of the issue in this case.

[@user-pm2yy1lp7m]

Leveling

[@SlicePrintRoleplay]

The bed being out of level could certainly cause adhesion issues. However, that was not the cause of this issue.

[@necozzIDK]

New or better plate

[@SlicePrintRoleplay]

Correct! I swapped the bed out for a smooth PEI bed.

[@rowdyrod]

Did you increase the bed temperature?

[@SlicePrintRoleplay]

That's a good guess because this was 100% an adhesion issue. But no that's not what I changed.

[@rowdyrod]

@@SlicePrintRoleplayDang! The only other thing I can think of is that you cleaned the bed plate/cover to improve adhesion, otherwise I'm stumped 😂

[@jo_bro666]

Glue on the bed to stop the first layers from shifting

[@SlicePrintRoleplay]

You are so close! But no I didn't put any additional adhesive on the bed. Great guess though!

[@rosalyschijf2157]

Z offset? Or something to do with bed adhesion, like bed level or plate.

[@SlicePrintRoleplay]

You are very close!... Can you explain what you mean by "or plate"

[@yousyoussef14]

Brim

[@SlicePrintRoleplay]

Good guess but no, both prints had brims.