Fiber Laser engraving an Anubis logo for Subcon Tactical

[@JuliaSanakoeva]

Please, don't stop posting such videos, they are so helpful, cause i could not find any normal tutorials in english till now... Thank you!

[@polakis1975]

I thought you set once the correct timing with the test you have shown in the other video and you are done😱 do you have to play around with the timing values in each job?

[@ajimachining2537]

No only if the speed change is drastic. Changing the hatch pattern does not affect the speed.

[@BiancaB-uc4mv]

Great Videos! I was wondering why the "s" that is white in the Logo, in ezcad, appeared to be engraved. I had a similar problem with a design I engraved. Is there a way to stop the laser from engraving certain areas even though it is a closed section. It was white, no hatching inside, but then it engraved that portion. It does make sense that the "s" in that logo needed to be engraved, just wondering if you fixed that to "hatched" in a later video. Thanks again for taking the time to make these videos! Very useful!!

[@ajimachining2537]

Keen eye you have. This was not the actual file that I ran. The file I ran did have the "s" hatched is ezcad2. Sorry for the confusion. You can select parts of the art and on the botton check the box that says mark selected. It will only engrave what you have currently selected.

[@stanz4142]

Can you tell me please what type of safety glasses do you use with fiber laser?

[@andme9408]

When you use the light button on the bottom to preview where its going to laser, is there a way to see the entire picture not moving, or is it always going to move. like when you write 3 lines of text and it shows it but it moves as it previews

[@ajimachining2537]

kzbin.info/www/bejne/eHXIepWZmaqKjJY Hope this helps

[@TheMavijo]

Hi you have some mail, to contact you, I have a question about the marker.

[@ajimachining2537]

[e-mail]

[@andme9408]

@@ajimachining2537 Hellow, when i do the light preview of what im about to laser, if its text it shows it but fast, if its a picture it only shows a box. Is there a way with text to have the preview stay without moving if i write more then 1 line of text