How to Build a Twin Tip Kiteboard Part 2 Building the Rocker Table

This is our 2nd video in our How to Build a Twin Tip Kiteboard series. In this video we'll show you how we built our rocker table. This is the jig or form that will give our board its rocker (curvature across the bottom lengthwise).
Materials and tools used in this video:
5/8" plywood- 1 sheet
drywall screws
1/4" LDPE (low density polyethylene) glossy
double sided carpet tape
Partall #2 greenwax
In the next video we'll show how we made the fiberglass skins for the kiteboard.

[@janeromnicki6598]

Woodglut instructions is nice for that.

[@kisoia]

Thanks for the video, looking forward to more :)

[@YuriyKhovansky]

I have done very similar with woodglut designs.

[@magicman9486]

Any idea when you will have the next video?

[@berkkadakgil3083]

great!

[@marcellojackiceman]

what are the measurements of the table? width and length? thank you!!

[@FiberglassSupply]

24" wide x 71" long. (61x180cm) If I built another one I might do it a little wider.