I've an issue with p2564 after fitting a new actuator. Same engine. I have 5v from actuator plug but signal shows nothing. New boost pressure sensor too. Any ideas?
@kieferste2 жыл бұрын
Was there signal with the old sensor also are you back probing the plug you should have something at the sensor plug if the sensor is working is the ground ok too
@deltafit Жыл бұрын
Where are you based mate? I can hear North East. Are you mobile?
@kieferste Жыл бұрын
I'm up near County Durham and yes I am
@deltafit Жыл бұрын
@@kieferste I'm in the Peterlee area mate would you be able to come and have a look at my Ford Transit Custom for me?
@kieferste Жыл бұрын
Yeah defo stevo188204@outlook.com give me an email with your details let me know when you have and I'll give you a message
@deltafit Жыл бұрын
@@kieferste I've emailed you mate. Just incase in goes to your junk folder. Cheers.
@Itemsbybizzare2 жыл бұрын
What sensor was that?
@kieferste2 жыл бұрын
The boost solenoid mate
@Haydzx-tn3gy Жыл бұрын
I have this code I change that sensor but still the same is there any other sensors
@kieferste Жыл бұрын
Have you done the same tests as in the video mate you need to see what your getting as in voltage at the plug
@Haydzx-tn3gy Жыл бұрын
@@kieferste no mate will go through it again tomorrow i only have a standard multi metre will this work? i put the car in the garage they said it had a code for the wastegate i replaced this today but i still no code p0045 open circut my cars S max 2. tdci 2010 euro 5 engine
@kieferste Жыл бұрын
Yeah a standard multimeter should work mate
@Haydzx-tn3gy Жыл бұрын
When testing the boost solenoid plug do I need one on the battery and one on the plug? What sort of reading should I be seeing mate I’m with the car now
@kieferste Жыл бұрын
@Haydzx-tn3gy yeah the earth on the battery and see what readings you are getting it's possible that the voltage is out of range