Fiesta ST Subwoofer Installation

Putting a kicker sub and sundown audio amp in the fiesta ST. Had them in the garage and quarantine got us bored enough to toss them in! If this helps please give us a subscribe to support the channel and please comment with any questions. Thanks for watching!

[@__diegoortega__]

Awesome video!

[@gapperformance]

Thanks! Just doing our best to help where we can. Drop me that sub :)

[@loganewing4222]

I don't normally comment on videos but I gotta say that this was a huge help, I basically mimicked this entire setup and it worked beautifully. I do have one question though, I just wanted to see what your amp is tuned to? Like what do you have your subsonic, reverb, etc. set to?

[@gapperformance]

Thanks for commenting! Are you using the same amp? I’ve since switched to a different setup and can’t remember the original controls, but basically I just tweaked them around until it sounded best from the drivers seat. Glad I could help you out and I hope I earned your subscribe! Thanks!

[@stronkwurks]

Previous owner ran the power in my '16 through that side grommet and now there is a ton of rust up underneath the dash and seats. Just so ya'll know, it will probably let moisture in, probably not the best way to run it long term. Forums say theres a grommet behind the glove box that you can use to push the power from the inside out into the engine bay. I'll be replacing the PO's system, and will be using this method in the replacement.

[@gapperformance]

I mainly went through the side because I’m not flexible enough to get under the firewall. Haven’t had any moisture issues with the doors closed, but my door seals are intact and I keep an eye on everything. Going through the firewall is definitely the preferred method, but this is easier on the back. Thanks for watching and please subscribe!

[@matthewshaw6908]

Plug and play kits saved me from tapping in it plugs between the factory harness and the radio, 68$ tho but saved time

[@gapperformance]

Yeah they help a ton, if my little bro hadn’t been helping that would have been my go to. Pro tip!

[@branondratliff6374]

What website did u get it from??

[@vxscenario1359]

Do you have a link to the plug n play kit?

[@mus3166]

thank you Bro👍👍👍👍👍👍👍👍👍👍

[@gapperformance]

Glad we could help, please help us back with the sub!

[@ricardoanorga5281]

Hey man just wondering when you started tuning and setting your gain what volume did you use on the stock head unit? I’m an audio noob and just put a sub in my fiesta st and really need help just figuring out at what volume the stock head unit distorts?

[@gapperformance]

Ricardo Anorga I didn’t use the stock head unit at all. Did a tap off the front right A pillar speaker wires for a line output converter to rca. All adjustments were done on the amp

[@ricardoanorga5281]

Casual Car Talk ok, I have a powered usb so my only controls are gain, bass boost and lpf so I’m trying to first figure out when the stock system begins to distort with my gain set to 0 before I start trying to actually set my gain and bring it up to the point before it will start to clip. This is the correct process to set gain by ear right? Like I said I’m pretty new to this.

[@gapperformance]

Ricardo Anorga if it sounds good it’s good :)

[@untitled0086]

Do you need to connect the line output converter? Like what exactly does it do. If I have an aftermarket stereo unit.

[@gapperformance]

If you have an aftermarket stereo it’s easier to tap off the speaker lines. The LOC is essentially what syncs up your sub to whatever music you’re playing by piggy backing off the speaker wire. The rear wires in that panel in the video are the easiest access to the speaker wires and that’s why I picked it. If you had a head unit already wired up, it would probably be easier to tap off those speaker wires. My 98 Honda covid is super easy to find speaker wires for, but pulling the dash on a 19 fiesta is a whole nightmare lol. Please subscribe to support the channel if we help you out! Thanks for watching!

[@thomascarter7447]

How did you plug in the RCA cables in the radio?

[@gapperformance]

I didn’t. The LOC taps of the rear speaker wires giving you the input you need to the amp. The amp then sends the signal to the sub in line with the rear speaker wire LOC tap. So you’re never connecting it to the radio per say.

[@Sdrummer51]

what fuse would you suggest if i don’t have heated seats?

[@gapperformance]

I also don’t have heated seats so I would use the same fuse I did in the video :)

[@mathieudanis6280]

What fuse could i use if i have the heated seats?

[@ericpowell9732]

@@mathieudanis6280 You could try the moonroof fuse

[@Mickger]

How did you connect the blue wire to the F17 fuse?

[@gapperformance]

Do you mean the add-a-fuse? (Fuse tap)? It’s been a few years so I need a memory job. I’ll watch through and see if I can find it

[@miguellayug6792]

Where do you tap the knob control for the amp? Is it the same line for fuse tap?

[@gapperformance]

Knob control comes from the amp. Looks like a little Ethernet plug in of sorts. Thanks for watching! If you can’t figure it out I can take pics when I get home

[@miguellayug6792]

@@gapperformance thanks mate. Appreciate the pics if u have time. Just to make it clear the remote out goes to the fuse box and remote in is for the control?

[@miguellayug6792]

@@gapperformance hi does the remote wire for the line converter should go to the fuse box or i can just tap it to the remote wire for the AMP?

[@gapperformance]

@@miguellayug6792 I just ran the loc off the speaker wire, the. Then I connected it to the amp with RCA cables. There is a little remote knob on a long wire that plugs directly into the amp. I ran that remote wire from the amp all the way up to the glove box to control volume. Does that answer your question?

[@gapperformance]

@@miguellayug6792 you could hypothetically connect the remote wire to the amp and just leave it in the trunk if you want. You can run it anywhere you want

[@nonsenseandcraziness]

but how is it connected to the head unit

[@gapperformance]

It’s not - it taps off the speaker wire with the LOC unit I tapped. Brings speaker signal to rca which plugs into the amp. Works awesome for the fist :)

[@garrettross2561]

Where did you get the amp adapter to do the tap??

[@gapperformance]

Garrett Ross Amazon, wasn’t expensive at all

[@josecortese9585]

You could’ve bought an adapter that goes on the radio harness

[@gapperformance]

Feel free to drop a link, we weren’t able to find anything in our budget. Thanks for watching and please subscribe!

[@antonisssbtw400]

Where can I get it

[@gapperformance]

I typically get comments like this that criticize without providing the “easy solution.” Sorry!

[@ianalexander716]

Is the brown wires the rear speakers

[@gapperformance]

I honestly can’t remember. If you pull of the rear door panel you should be able to backtrack directly from the speaker itself

[@ianalexander716]

@@gapperformance i wonder if the ford fusions are the same