Рет қаралды 1,776
Got a rearview mirror that falls off periodically? In this video I show an alternative way to mount it that so far has worked great.
Epoxy I used: amzn.to/3Ocy9ef
#wjhandydad #epoxy #DIY
www.WJHandyDad.com
0:00 Ford Crown Victoria police interceptor 2010 P7B
0:40 mark the glass location
1:26 failure point seems to be the mirror button not the glass
1:55 clean glass thoroughly with isopropyl alcohol IPA
2:21 how do you remove the mirror button
3:24 scrape the button clean
4:20 sand with 80 grit sandpaper to scuff the metal
5:09 clean the mirror button with isopropyl alcohol IPA
5:25 different rearview mirror adhesives
6:35 my tip for using the Gorilla epoxy
7:35 prep with painters tape
8:24 apply epoxy to mirror button
9:05 mount mirror button with epoxy and painters tape
10:02 cure for at least 24 hours
10:20 temperature needs to be cool - probably 50-70 degrees F
11:47 mount the mirror to the button
Disclaimer:
Due to factors beyond the control of WJ Handy Dad, I cannot guarantee against improper use or unauthorized modifications of this information. WJ Handy Dad assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. WJ Handy Dad recommends safe practices when working on vehicles/homes and or with tools seen or implied in this video. Due to factors beyond the control of WJ Handy Dad, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not WJ Handy Dad.
As an Amazon Associate I earn from qualifying purchases