Fixing oil filter leak and dipstick leak on a Lexus LS430 or Toyota Celsior 3uz , Or LS400 1uz

The Cartune Company (2003) Ltd in New Zealand does 1uz and 3uz conversions / parts and wiring. We have been working on UZ Toyota V8 engines since 2004 when we did our own Hiace van to transport dirtbikes around NZ. Since then we have swapped to doing mainly just Lexus V8 work from a family owned farm hidden away in our paradise , surrounded by the NZ native bush. We sell parts and simple to follow wiring instructions for the 1uzfe engines. For enquiries email [e-mail] Take Care. Kelvin

[@smashingartful]

Thank you thank you! With this video I have the confidence to attempt these fixes on my car!

[@YhAFbwts]

"don't go in dry", words to live by. especially relevant with these "old girls" vintage models.

[@CartuneNZ]

Never go in dry, this is very important, and the hole is often not quite where you expect it to be. haha. cheers Kelvin

[@MannyLS400]

I did the same thing with replacing that figure 8 gasket I have parked it on a slope and noticed it was leaking from the same location is there any specific torque specs to use or do I have to oil the o ring up to get a proper seal? Any gel is greatly appreciated

[@howa15001uzfe]

Have you any tips for testing a 1uzfe oil level sensor? Do you need a pan of oil on the stove as per the lexus manual? I dont think the mrs would appreciate her best pans and jam thermometer getting used to get the oil to 60⁰

[@johngutierrez4882]

Hey Kevin would the gasket from the lx470 fit the gs430 for the oil filter assembly

[@Jack14432]

Where are you mate?

[@bvward]

Kelvin, I like a little dab of Permatex Aviation just in case...

[@CartuneNZ]

I agree and If im unhappy with the surface then a tiny bit of suitable sealant is used, My weapon of choice is loctite 518 flange sealant. In many cases I try to avoid it but I also only like to do it once, and I use the minimal amount.

[@nct9466]

No lathering of shilicone on all O rings lol!?

[@CartuneNZ]

No - nor should there be silicone on the thermostat housing. Cheers Kelvin

[@zorsts]

lot more room with a Bedford