Fixing rear arch (and few other things) on Golf MK2 GTD

[@preneshpakkiri5565]

Well done buddy awesome work lots of love from south Africa Johannesburg 🇿🇦 will be nice to see it on nice wheels and bagged

[@honestmileage5225]

Thanks a lot :) I am looking forward to see it low and on nice wheels. I am thinking about japan racing jr31 or maybe I will borrow bbs rm from the other golf I have 🤭

[@themediocretriathlete]

Awesome work...great progress.

[@honestmileage5225]

Thanks a lot 😇

[@kajonagyeri360]

Amazing progress! How much percent do you think till you ate finished?

[@honestmileage5225]

Well, hard to tell, but I assume I am around 25 % now, so 75 more to go 🫡

[@johnbird2703]

Why didn’t you fit the whole floor panel to rear section?

[@honestmileage5225]

Thanks for your question. Reason for not changing the whole panel is that I believe that original panel (when its not corroded) is in better quality than replicas. So I am trying too keep as much original panels as possible.

[@neonaffliction]

Nice progress. My cheap ass would take a brush and dip from the floor.

[@honestmileage5225]

At first I was thinking the same 😁 But the floor was quite dirty from grinding, so I just cried a little and cleaned the mess 🥲

[@shkelqimaliu4126]

Oh man, that wurth rust converter is really expensive...

[@honestmileage5225]

Oh yes 😁 But I am very happy with the results. On the car I mean. Now even the floor will be never rusty 🙄

[@shkelqimaliu4126]

@@honestmileage5225 my golf mk2 is pretty rusty in the trunk area, I was thinking using this for the rust at least it will slow it down.

[@honestmileage5225]

Unfortunately I cannot tell at this point any long term experience, but i expect it will help 👍

[@miniek83]

My fiend never dip dirty brush into container directly!!!

[@honestmileage5225]

Noted, thanks for the advice 👍

[@AutodidactEngineer]

Bird poop welds

[@kajonagyeri360]

I bet your comment reflects your personality… shitty :/

[@honestmileage5225]

Thanks for your comment, do you have any suggestion how to improve weld visual quality ?