In this video I flush the Heater Core plus flush and refill the cooling system
Пікірлер: 53
@bigdawg11085 жыл бұрын
I ended up doing this, because I had flushed my car's coolant system four times. Still was getting a cold heater. I used Draino instead of CLR. Then used dish soap. Flushed it out both ways several times out with warm to hot water. Now my heater works like a charm. Thanks for your information!!
@allenpaley3 жыл бұрын
GREAT camera angles, GREAT editing for brevity, I'm definitely going to subscribe!
@nickplaisance49914 жыл бұрын
Lil bro that was the best step by step procedure that I seen yet and I researched for a week.. I appreciate an all out effort!! You got people wanna post stuff and leave Lil things out when an inexperienced person will get lost..People need details and results(that’s the only problem)you said you’d let us know either way but didn’t..Man answer them peoples questions (they are ya fans and followers)me too!!In this regard!!lol..Don’t worry about haters do ya thing!!
@Cosimo77777775 жыл бұрын
Best video out there on this. Provides experienced knowledge along with a DIY perspective; figuring things out. Thank you.
@bubav83 жыл бұрын
CLR eats the aluminum! So should be great lol. White vinegar works exactly the same way for a fraction of a cost. Good luck everyone.
@timothycarter72536 жыл бұрын
Great video. Did the CLR work on the heater core?
@kelvinwilliams38373 жыл бұрын
Hello brother, I loved this video, now I can clean my car, so that it is hot, thank you, it has one more follower.
@THEMRMURDER2702 жыл бұрын
Thanks mate. I have a avant B5 with the 2.8 engine. Tomorrow I will do the same
@braydensdeals7 жыл бұрын
Hey man, nice video, I would like to see a conclusion on your videos. Often you do a project and upload it. Would be nice to see how it all turned out in the test drive. Not hating, thumbs up man
@chadscott84693 жыл бұрын
There’s another video that has results
@Highspoolteacher3 жыл бұрын
I’m looking at buying a 2002 B6 1.8T avant that won’t make any heat. I’m hoping this will be the solution for me. Thanks for the video!
@seanthomasrauchert16954 жыл бұрын
I soaked the heater core over night with clr worked amazing crazy amount of crud came out! Great vid
@foosreviewfood36975 жыл бұрын
Great video bro but did it endup working?
@theelle79413 жыл бұрын
Can I flush the system without flushing the heater core? Because my coolant is brown but not that brown I put the correct coolant in but I think the people that it before me used the wrong kind. Coolant isn’t low but the warning started flashing maybe a month after I topped it off.
@sherkhanbaloch96975 жыл бұрын
Wahhh So what was the end result did the heat work, Here in Canada it's freeeezing cold and my 03 Audi A4/ 1.8T heat hasn't worked in years.. we be running tempt portable plugin heat for past two years, it's time to move to south America missing hot sunny days..
@seanthomasrauchert16954 жыл бұрын
Audis are famous for the I too miss the south use to have a house in Florida why did we settle in Ontario oh I can't wait for winter and scraping the inside of the windsheild lol😂🤣😂
@chadscott84693 жыл бұрын
How did the CLR work in the long run? Any issues?
@noyawiosman7616 жыл бұрын
Hi, My Audi A4 2.0 heather not working, can you help me for this? Thanks
@_R0N1N5 жыл бұрын
How did you figure out which is the inlet and outlet hose ? For heater core I can't figure it out on my Audi A4 03
@gregorythoman82815 жыл бұрын
On my 06 A4 1.8t the heater hoses are on top of each other the supply side is the lower hose and the return is the upper. But, you can tell which is which because the supply comes from the coolant flange at the rear of the engine.
@tirecchatman5475 жыл бұрын
Did it work have same problem
@imabongibanga69372 жыл бұрын
Me, a 23 year old girl looking at this knowing I gotta do this 🥲
@flyingyakdeath6 жыл бұрын
I don't know if Dexcool is compatible with G12 or G13 (the coolant spec for your car) but I would imagine neither GM or VW/Audi will declare that. Use the right spec.
@gregorythoman82815 жыл бұрын
You can get G12 at most parts stores. I switched to G12+ (Purple)
@jessekozazcki62125 жыл бұрын
@@BUILTOFFICIAL that's very wrong. Coolants are different from each other. If you haven't yet, get ready to experience massive coolant system issues
@nickbaker8203 Жыл бұрын
Long shot since this vid is old but is this a 2003 Quattro?
@dhalkinne16 жыл бұрын
Was it successful? Did you get your heat back going? I’m having the same problem!
@pasalexander16415 жыл бұрын
@@BUILTOFFICIAL Hey , just wondering about the bubbling sounds on heater core. . I hear those sounds too. Could be the sign of air presence in cooling system .Just wondering if trying to bleed the heater core would help me . Thanks
@martinee49014 жыл бұрын
The main reason the A4B5 heater won't work. It's the foam on the heater box flaps has disintegrated. To check, remove the centre vent in the dash & look for bits of grey foam. If you find it, you need to remove the heater box & glue new foam over the flaps. A cheap, but time consuming job to remove & replace the box. Be patient. It can be done. Remove the actuator motors & cut thru the carpet under the box for better access. Remember the movement & positions to get the box out do you can get it back in.
@martinee49014 жыл бұрын
Or you can remove the whole dashboard. If not, you will need to cut thru the centre upper vent duct & reflux/seal it back on afterwards. I looked some nichrome wire around the back of it, as high as possible & connected wires to it & a car battery to 'hot wire cut' thru it. Depending, removing the dash might be better.
@Mike-my8fb3 жыл бұрын
What size hose did you use for the flush?
@bseclipse214 ай бұрын
States 3/4" in video
@OhYeahAboutThat7 жыл бұрын
I flushed the cooling system in my Miata project 12 times and it was never perfectly clear! I need to flush again with a dedicated cooling system flush and see how that works.
@gregorythoman82815 жыл бұрын
I do not recommend using CLR. Always buy a coolant system flush. CLR has detergent in it which will screw up O-rings etc. Never use any coolant that is not specifically recommended by the OEM.
@_k808x__64 жыл бұрын
I have an Audi A4 1.8 97 it doesn’t have a plug by the radiator plz help :(
@virginiacoupal43374 жыл бұрын
So.... did it work?
@carterhoiland56724 жыл бұрын
I read you can use g40 in the audis as well. anyone have any more input on this?
@CoHoLYFE3 жыл бұрын
G40 is what I have in my audi and no issues
@iroquoispliskin60773 жыл бұрын
G12 was original but G13 or G40 work as well.
@josephsevern58424 жыл бұрын
Hey did your over heat at all
@gregorythoman82815 жыл бұрын
Does the heat work? That is the big question that you didn't answer.
@daemonbenni5554 жыл бұрын
Idiot
@aldocruz76365 жыл бұрын
You look so much younger without a beard like if you were 19
@Justin-tw8ws6 жыл бұрын
The heater core is actually pretty easy to change in the A4, can get at it from the drivers footwell.
@neilcharlesyoung5 жыл бұрын
you are so wrong. first you need to take out the a/c condenser in the firewall.of course you have to have a machine to get the refrigerant in the a/c system then you have to take the glovebox,center console,then you will see it in the PaSSENGER SIDE.then you have to get the whole A/C and heater core in one assembly unit. takes about a day to it. EASY LOL
@seanthomasrauchert16954 жыл бұрын
@@neilcharlesyoung nightmare of a job ! But yea if you can do it in a day I bow dwn 😂🤣😂
@martinee49014 жыл бұрын
Nah, it's a pain, remove whole dashboard, A4B5, or remove the clips holding it to the aircon box & cut thru the upper centre vent & reseal it afterwards, there's no need to keep the springs holding the centre vent.
@vincentrobertson816710 ай бұрын
you did not show how to get that front bumper off, one second you were messing with those two little black plastic grills , then next scene ,they are magically off.
@alexlaverick61115 жыл бұрын
GM's DexCool did the same clumping BS. What a waste of time after doing a half assed flush. Use some CLR in the core for a few minutes before you flush with water. You realize by taking shortcuts and using wrong products that all you are doing is fucking up others. What did you do with all the toxic waste from the job. Where did you dispose of the coolant?
@MotoDJS1KRR6 жыл бұрын
You’re gonna destroy that heater core if you don’t use the right Coolant G12. It’s good with all the seals and such in the system
@terrydietzler40962 жыл бұрын
Apparently it was unsuccessful. Save yourself 13:26 and try another video.