Fixing up our powermatic 6” wood jointer

[@ivanbacon5753]

Curious that you are adjusting the out feed table. The out feed is the constant from the factory that everything else is set to , I.E. referencing off of. The knives are adjusted to match the out feed table and the in feed table is adjusted to match, be co-planer, to the out feed table.

[@contemporarywoods243]

This jointer had been moved several times and the end of the outfeed had dropped on the end so every pass we made we had a crooked cut, but after the shims and fix we have a lot straighter board

[@IndianaJBird]

A machinist straight edge should be used for this process.

[@pnfoster]

Not properly done unless you use rusty feeler gauges.