FJR 1300 Fork Assembly Part 1

FJR 1300 Fork Assembly Part 1

[@rodmitchell8064]

Ok,now I see now that your working on a Gen 1 FJR, it only has 1 bushing under the seal, mine is a 2006 ,Gen 2 with a second bushing below the upper bushing, Yamaha doesn’t sell the special lower bushing driver here in Canada anymore so I made a lower bushing driver out of a 4” length of 2” exhaust tubing cut lengthwise and lined with clear packing tape

[@robertbond582]

Sure would like to see, at what stage (order) that lower outside bushing is installed.

[@rpoz11]

Great Video and dermonstration! Thanx for this....

[@hornet224]

Explained with rapid fire military precision including operating mechanical function of the parts No shade tree mechanic here.

[@klangheld]

Thanks for the how to assemble video. It's there a how to disassemble video.?

[@deniscasique3936]

Hola pedro tengo una FRJ 1300A Y NECESITO LOS 3 DELIZADORES O BUSHING donde los.puedo comprar, me.puedes ayudar u orientar gracias

[@rodmitchell8064]

What about the 3rd mid bushing ? About 3” below the seal ??

[@ALLENWOOD123]

I was just thinking the same

[@warrenflint9950]

I'm struggling to get the bolt back in the bottom of the fork. Is there anything I'm doing wrong? Do I need to make adjustments before trying to refit the bolt ?

[@helenevillemure9178]

Hold the sub-assembly upright and gently wiggle the cartridge inside, holding the plunger within the stanchion. You should hear a "click" when the threaded heel of the cartridge finally falls in place in the tapered bottom piece. Hope this helps.

[@MrFiXXiT88]

How much oil did you put in the fork?

[@georgetech380]

Hi I am trying to fit new seals and springs on my fjr ,I can see that you fitted 2 bushes ring ,one that goes to the upper piece by hand and one goes to the bottom piece the one required the special tool ,but when I tried to wash the bottom piece a 3rd bush ring came out of it and I got confused.......where this one goes ? My one is gen 2 2007

[@SteinarPladsen]

Question 1: How to support the front of the bike (exhaust's...) Question 2: What size Fork Seal Driver kit is needed for the FJR (04)? Tnx!

[@vvkilin]

I missed - is there moment to remove upper bushing from the outter tube?

[@billbonu1639]

It's a shame all those seals had to die so he can have grease for his forks!

[@deniscasique3936]

O alguien que me pueda ayudar

[@0n596]

Not useful because it is not clear what parts you put in to reassamble. Rather than showing the shop you want to give a close look of what you put together. Unless this video is for Yamaha shop mechanics.