Yamaha FJR 1300 front fork disassembly / oil and seal change / teleszkóp olaj és szimering csere

[@bradjarrett4756]

Thanks for sharing this. I am doing my seals and I will be following your sequence.

[@latzkoworks]

Thank you for watching my video!

[@bradjarrett4756]

@@latzkoworks I appreciate you doing it mate. It's really important to put the forks back together in the correct sequence, and your video is clear and precise.

[@latzkoworks]

Nothing special. It takes about 2-3 hours. Have a good luck and Merry Christmas!

[@georgetech380]

Hi if you can give me advice much appreciated, I am.doing this job ,I removed the upper fork from the bottom exactly like you did it ,both bush ring came out ,the washer and the seal ,but when I try to clean the bottom piece another 3rd ring bush came out .......only asking because on your video I can see only 2 bush rings

[@latzkoworks]

Hello, yes, in some types there is one more bushing ring, so one on the inner tube end and two at the top of the bottom part.

[@georgetech380]

@@latzkoworks thanks yes after 2-3 hours I understood it ,on gen 2 2007 there is 3 bushes ,the 3rd one is rest in the middle of the bottom piece..... thanks

[@latzkoworks]

You are right ✌️

[@muaazsheikh3192]

What year is this bike? I'm my forks are stuck and I can't remove them to replace the bushings on my '06 Fjr!

[@latzkoworks]

Hello, as I remember it was from 2003.

[@angelman4164]

Same here. Got it unstuck. Did you put all 3 bushings back in or did you leave the middle one out.

[@latzkoworks]

Hello, I have only replaced the sealing, have put all the original parts back.

[@alvarosilva8077]

Hi, I saw your videos about fjr front forks, You are using a repsol 5 w ? Is not a 10w? In My bike I using a 10w and is so soft..

[@latzkoworks]

Hello, in the repair manual was written the 5w. The original springs used to be too soft after time.

[@alvarosilva8077]

@@latzkoworks Hello, thanks for your answer, yes, it could be the springs that are tired, I have a problem with the starter motor, could you show me how to get to it to remove it?

[@alvarosilva8077]

@@latzkoworks you already have one more subscriber😄😄

[@latzkoworks]

@@alvarosilva8077 thank you 😊

[@latzkoworks]

@@alvarosilva8077 about the starter motor: I can't tell you anything, I did not removed it from this bike.

[@warrenflint9950]

I'm struggling to get the bolt back in the bottom of the fork. Is there something that I'm doing wrong. I have an fjr1300

[@latzkoworks]

Hello, nothing special. Just install the inner parts in the right sequence, hold all them horizontally, and push them together. After that you should lift up a little bit the upper end, and turn the bolt in.

[@warrenflint9950]

@@latzkoworks thanks. I'll try again