FLYWING lets talk ESC

[@AlexBongRCFunLand]

Roy, the mosfet used is 30V 78A. PCB printing doesnt reflect the actual power.😊

[@frederickgrassie3383]

Cruz, thank you. Plug was damaged by me when I used needle nose plyers to pull them apart.

[@CRUZROYHelicopters]

you noticed fgbfstfgbfst7294 new to youtube is explaining why a new v3 esc has old label, i would recomend not flying 6s till i investigate, esc's are hard to get and expensive when there going to pop on a blade strike or small crash

[@iriquiosgunship]

Flywing customer service was useless for me. I have the same problem. Thank you for sharing.

[@fgbfstfgbfst7294]

Because at the beginning of V2 design, the version number was initially defined as 4S 30+15A. But later on, the MOS and board thickness were changed to increase to 60A 4S, and then changed to 6S 60A. You can check the specific MOS chip model, which I remember correctly should be 70A MOS。

[@CRUZROYHelicopters]

this is a new esc, from v3, so you saying you did not change label on PCB so it still says 30a15a4s2in1v1.4 ??????? so v4 version has same board, i will check fets on this board and check back