FMF Gnarly | Installing a new Pipe on my Husqvarna TE300i

[@mikeyx2415]

Did you notice any significant loss of top end power when using this? Thinking of grabbing one for a little more oomph on the bottom to mid but don’t want to absolutely gut out top end for it, losing some overrev and such is fine by me though

[@MALVSMACHINE]

To be honest Mikey, I don’t remember much difference, but you’re probably a much better rider than me so will probably notice more in a change of power than I would 😄

[@gvnthomas]

Shiny!

[@MALVSMACHINE]

Certainly is! I hope it stays that way too….. it’s supposed to give a bit more bottom end grunt but I doubt I’ll notice it 😆

[@gvnthomas]

@@MALVSMACHINE Even if you don't notice it you can still say it's there plus Shiny!

[@MALVSMACHINE]

@@gvnthomas absolutely 😆

[@TruenorthmtGod]

I have a 2024 will it work?

[@MALVSMACHINE]

I haven’t even seen a 2024 model yet dude so don’t know the answer. Would be worth checking the FMF website to see if they make them for your particular bike before buying 👍🏻

[@jarredtremain4644]

Got same pipe ready to fit my 18 te300. Was told take muffler off to install expansion chamber properly in line and seated. May have to trim a little bit off joining end of chamber so that everything lined up and not forcing pipe out of line with head. Bit of grease or silicone on orings makes it easier to install and seals better. Avagud1

[@MALVSMACHINE]

Cool stuff, they look great! I ended up loosening the muffler to fit mine and it went in no issue, I just had a nightmare getting the second bolt to meet the thread. I got told off by a family member for not putting grease on the O rings so will remember that from now on😆. Hope you enjoy your new pipe mate 🤘🏻

[@jarredtremain4644]

When trying to fit springs in to motor before pipe, pull hook out hard on one side and wedge abit sideways, this will help hook stay extended and in position, then softly with hand and don't touch anything until in position on head. If do hit hook it will fall into spring easy. Avagud1

[@MALVSMACHINE]

Thanks very much Jarred, I went in blind with this one and the springs caught me out 😆.