Focus XR5 Turbo / ST225 Hub & bearing replacement with lock brace by OEM Denied Performance

Guide on how to replace a front wheel bearing/hub on a Focus XR5 Turbo/ST225 and how to install lock brace.
Wheel bearing/hub walking out of the knuckle is the most common cause of DTC's C1141 & C1142.
Bearings and braces available from focusonperformance.com.au/fro...
Step by step by OEM Denied Performance

[@AlanXR6]

Great video Jamie! I've now learned something new about my XR5! Please keep doing more of these types of video's if you can :-)

[@johnmelling9950]

Wow, this seems a crazy design. Am I right in thinking that when on the vehicle, the only thing keeping the wheel and hub on the car is the press fit and retaining compound? What's to stop that bearing walking out until the whole wheel and hub come off? Am I missing something?

[@OEMDeniedPerformance]

yes and no. Yes it is just the retaining compound that holds it in place as its designed to be an interference fit. But no the hub cany physically walk all the way out the knuckle to the point where it can come off as the driveshaft's outer section goes through the hub and knuckle. but the shaft cant fit through the space where the hub/bearing is + even if it could the brake disc cant push past the brake caliper. Its a design that Ford inherited during their Volvo ownership, Volvo realised the issue with the hubs walking ever so slightly out and causing the ABS errors and then developed the locking brace. The mk3 Focus on the other hand being a newer vehicle has a circlip that prevents hub walk out

[@stevo853]

would it make the car loose power if one of the abs sensors dont work ?

[@OEMDeniedPerformance]

usually puts car into limp mode briefly till reads a signal again

[@gregorylichtenson757]

These can be installed on Vehicle as well..if not changing Hub Correct??

[@MarcioSilva-yf4pl]

Will a 6tone bench press do the job?

[@OEMDeniedPerformance]

should do. Sometimes they move at around 2T worth of pressure but I have had them not moved till 6T before. Not very often though

[@Sloposse]

Wow no circlip in hub hub carrier what stops the lot pulling out?

[@OEMDeniedPerformance]

The idea behind Ford's design was bearing retainer compound would keep them in place. The next generation Focus knuckles were redesigned to incorporate a circlip. A work around for the mk2 is the lock brace

[@Sloposse]

@@OEMDeniedPerformance christ im suddenly doubting the safety of my ride after discovering the front bearings are more or less just glued in and harnessing all that power and handling. Ive got a spare pair of hub carriers and have had a good look at them, what a ridiculous idea even though it seems to work. How do you get the abs sensor out without ruining it? Never been able to remove one from any car ever

[@OEMDeniedPerformance]

@@Sloposse Should just pull out once you have removed the torx screw. If knuckle is rusty spray Wurth Rost Off Ice on it and should then be able to pop it out.

[@mrhuss4939]

Hello, Where can I buy the brace from? Thank you

[@OEMDeniedPerformance]

@@mrhuss4939 focusonperformance.com.au/front-wheel-bearing-hub-locking-brace/