FORD EDGE MISFIRES NEW IGNITION COILS NEW SPARK PLUGS STILL MISFIRES. HOW TO FIX MISFIRE

[@AutoRepairGuys]

⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: kzbin.info ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys

[@sakibudawuda9770]

Please which shop can I repair my pcm

[@surrealnumber8166]

Thank you so much for this video! I was really concerned because I had already dumped $3k USD into tuning up my Edge, then this randomly started happening while coasting down the highway. I was lucky, all I had to do was disconnect my battery for 30 seconds & it hasn’t misfired since then. Good to know that it’s a faulty ECM and that it can be sent in for repair. Thanks again!

[@metalmonsters8me]

U guys saved me thousands with this video. SIA electronics took care of the ECM and I'm on my way again. Thanks so much.

[@jasonjuarezz]

Was this in the states? and how much did you pay?

[@LT-ms6je]

Who repaired ECU?

[@joehead1350]

Was wondering where you sent the pcm to get repaired . Got same problem on Mercury Mariner

[@metacombs]

SIA ELECTRONICS, [phone]

[@lashanacollins2283]

Can you share the repair shop you used?

[@harrysosajr8684]

You didn’t move the coil to another plug to verify whether it’s the coil or something else? I have the misfire with a new coil and it follows the coil to the plug i attach it to. how does that conclude the ecm is bad?

[@sedrickharris5535]

Hey guy we need videos on the 2.0 edge spark advanced on cylinder 1,, injectors, spark plugs, coil change, runs great driving but idling has a slight miss..

[@Larry-j9b]

Hey guys, please share the shop or the shop's that will perform a rebuild on the ECM? Thank you so much!

[@lvitale4071]

Where did you send your PCM for repair?

[@narcisosonnyagbayani5523]

master i ford edge 2013 rpm up and down while on part with ac or without ac no accelaration? change coil change trottle new spark plug same coming rpm up and down any solotion this problem

[@johneckler534]

Where did you send it too to get it repaired and how much was it?

[@thomasraudabaugh3879]

Where can I go to contact them to send my computer system in my car and what was the average price

[@angelisone]

Where did you send the ECU for the repair & how much?

[@keithcampbell4695]

My car is doing the same thing. I love this video. My question will be, where did you send your ECU to get fixed? Name, number and address.

[@youflyibuy]

Where did you hook up the volt mter. I didnt see and I dont know. Thx

[@juanpena1783]

Any updates, about where to send the computer to?

[@angelisone]

2010 Ford Edge Limited AWD is Spark Plug #5 is the center (3:48)? Shop replaced all parts like from this video but misfired P0122/P0174/P0205/P0223/P0305/P2110 with check engine light comes on after 12 miles. If Fuel Injector #5 is bad? And where is this location?

[@jjarboe2001]

center bottom

[@dashtyATG]

Hy thanks for your time. How come you didn't married the key to the ECU? im having a difficulty with immo here with a new ecu replaced ford edge 2007. Vehicle want stard what to do?

[@javiermonzon2806]

Is it 2011 Ford Edge 3.5 front-wheel drive had a mis-fire code of cylinder 4? This car has all new plugs, all new coils. A new injector in #5. Had to replace both catalytic converters because they were damaged. New fuel pump. Good compression. Idles good but under a load, i was losing cylinder 5. And eventhough its cylinder 5, it pops and thats why they changed the fuel pump. The car is from Pennsylvania but its in real good conditions; Bodywise and interior, and the engine isnt too bad. I belive it might be the computer. The driver is heating up. What do you recommend?

[@garrettsmith8]

Did you ever figure out your issue?

[@steveslavo4938]

Can you please tell me where I need to send my computer to get fixed because I am having this exact issue? Also what should I tell them the problem is? Thank you so much

[@ryanvance9623]

If you havent gotten this fixed yet. Circuit board mechanics dp amazing work. And for a good price.

[@Meatnewdadbod]

Is this the same Ford Edge with the same misfire problems that you have been working with the whole time? It started out by replacing the spark plugs the ignition coils the camshaft sensor and the fuel injectors??? And you finally figured out that it was the PCM??? I'm just asking because so far in my Ford Edge I have fixed new spark plugs new ignition coils and have taken it to two shops and one of the shops told me that my PCM is frying. I'm just wondering because you're misfires sound kind of similar to how a mine was. The misfires kept switching up to different cylinders and sometimes going the way and changing. Trying to get this crap fixed without literally killing my pockets and I have already spent almost $500 trying to figure out what's wrong with it and a lot of that is doing the work myself and taking it to two shops and getting Diagnostics done

[@lh5567]

Same here did you figure it out? This damn car is driving me crazy!

[@Kyounaso]

@@lh5567any updates?

[@baderalazaat2190]

I want to replace the computer due to a malfunction in the gear shifting. Do I have to match the numbers on the computer, or is it enough to buy a computer for a 2009 Ford Edge?

[@joshuacarter1554]

Hey I have 2012 ford edge we just replaced all 6 coil packs few mos ago ... now it seems it's doing it again skipping especially when you press the gas engine light is flashing and you gas kinda

[@josephhannold3739]

I have a 2013 Ford Edge 3.5 L and I have a P0305 code that just won’t go away! I have replaced the plugs, coils, injectors, o2 sensor, MAF sensor, Purge valve sensor and finally the ECU. I still have the P0305 code coming on. Any suggestions?

[@yume7z185]

Check the wiring harness

[@davidely6214]

Have u fixed this yet having similar issue

[@Kyounaso]

@@davidely6214any updates?

[@sakibudawuda9770]

Please where can I send my pcm to be without reprogramming

[@jamescollins8148]

I’ve had 2 different PCMs continuity from pcm to coils. Coils not firing!

[@wendisutton9033]

Can you use a 2011 coil in a 2013?

[@judithrivera2926]

Hello , I replaced my coils and two days after I got check engine on code p0430 can it might be a misfire from new coils

[@RonComstock]

who do you use to repair pcm?

[@jrt7851]

Where did you send the computer tobe repaired?

[@metacombs]

SIA ELECTRONICS, [phone]

[@ericcampbell1510]

Where did you send the computer to get fix?????

[@28drafting]

Great video!!!

[@d.b.1419]

If you took the battery cables off then It won't show a check engine light because you reset the memory? You will need to run the engine cycles for about 80-100+ miles

[@djprengel8334]

Never connect positive battery cable last. Hydrogen builds up in a battery as it charges at the positive post. You risk exploding the battery when it sparks. Always connect positive first.

[@honcho714]

You sir are full of shit.

[@4WingView]

Can you please post link to voltage meter. Also would greatly appreciate link to ford on board computer repair.

[@shell7998]

Hi so took car to mechanic 2011 ford edge it read it was misfiring bad coil just one he said he replaced it and it blew out called said I had to take car to dealer not sure what to do now ?

[@victorderick1215]

Hello sir good morning please my ford edge 2007 is not starting since 5 days now but the light is turning on but the car is not starting please sir what will be the problem

[@dustin5595]

Where did you send your computer

[@Bassboy1972]

Replaced my coil packs and spark plugs and sent my computer to the repair shop that’s mentioned and computer was fine. Still getting p0301 code. Running out of ideas to what is causing my intermittent misfires.

[@ryanvance9623]

I got the computer fixed and it worked great for a while. Now I have the same code (301). If you have found anything out please comment back.

[@sway3699]

We changed the cylinder one fuel injector & fixed everything got rid of the shaking

[@brrusso2943]

What if I change the injector and still the same

[@sway3699]

@@brrusso2943 more then likely you changed the wrong one so a injector still needs replacing

[@ChrisB-cx6td]

@@brrusso2943 get a good scanner

[@ChrisB-cx6td]

Also had the same issue and fix

[@mannymartinez7571]

Po301 2013 explorer after plugs ND coil change. Could it be injector. With out codes

[@dontrompas1312]

I'm just gona sell mine...replaced maf sensor and throttle body and still having problems..lack of power and misfiring...

[@GoldenStatesGaming]

I replace ignition coils, injectors, and repaired PCM and still have a missfire.

[@Dxfactor24]

Same here!!!

[@WildDisaster]

Check the cylinder compression. You could have a broken valve.

[@steventmln1st]

same here.i have a 2007 MKZ and I gave it gas to pass a car and it popped could so , I replaced all plugs and coils and pcm ..this year 2007 has tsb..says to replace everything so I did..still runs rough.chsnged massive air flow ..So I'm thinking it's in the wires as I'm getting po 305 and po174 .

[@steventmln1st]

and my compression is good

[@jalisahorton]

Fuel pump

[@sakibudawuda9770]

Please can someone help me where to fixed my pcm

[@stephenanderson1944]

Here's one for anyone who could help, replaced plugs coils AND PCM and still misfires at idle only up to 1500 rpm or cruising in 6th cylinder balance test shows cylinder A(1) showing wayyyyy off, cylinder B(2) is about half the other cylinders

[@RichardRLeal]

Pcm? Or ECM?

[@stephenanderson1944]

@@RichardRLeal PCM, the one that controls the engine which technically is either one PCM or ECM

[@JesusisLORD77778]

Did you ever figure this problem out? Having a similar issue myself

[@stephenanderson1944]

@jesusislord yes actually, part of my wire harness was laying on the engine and had melted the signal wire going to the coil, it was passing electricity through the aluminum valve cover to complete the circuit, had plenty of wire left so I chopped new ends and soldered it together haven't had an issue since

[@JesusisLORD77778]

@@stephenanderson1944 thanks a lot I will check mine out too

[@icefishinnhnewhampshire7688]

Hello please help anyone I cant find the link to the place he sent his pcm to to have it repaired with out programing

[@justinbowles7086]

Did you ever find out where he took the computer to?

[@jeremyvanwinkle5053]

Changed plugs wires coils injectors and new computer still misfire

[@keithcampbell4695]

My #2 COIL KEEPS MELTING.

[@johnstahl8413]

You can send you computer to “ Circuit Board Medics”. Ciruitboardmedics.com

[@judithrivera2926]

Hello , I replaced my coils and two days after I got check engine on code p0430 can it might be a misfire from new coils