Ford Ranger Budget Catch Can Install DIY

[@Mooncat747]

Provent 200 on Lazada Thailand is 350 baht, that's 10 USD. It also has a filter and bottom drain valve. Easily fits inline by cutting that existing line. Also, get rid of that air box and run the cone type. You will notice a huge difference. Modifying that stock airbox doesn't do anything. You'll also have way more work room once that air box is gone.

[@berndmanitzky1476]

How did you install the „oil return line“ to get the oil back into the oil reservoir?

[@shawnforbes6495]

Cone tye filters are impractical for 4wd condition you need air box with a snorkel or similar. Cone type straight filter are for road driving only

[@T3amBull3t]

Lover your channel. Wish I saw this before I bought the fancy catch can

[@mikecrafar6276]

Bloody good videos mate, very informative. Cheers.

[@renznews7445]

wit does the ranger 2.2 already have a catch can?

[@JOHN31six]

Hey mate, what is the size of the oem hose ? Thanks

[@TengokSkrin]

Sir, sorry this is out of topic. Is there any way we can open the rear cabin air vent. Because when raining. Water leaking through it.

[@joselolopez3635]

What is the reason for putting that reservoir in it? Does it use less oil?

[@vonlogan1]

I’ve done all your projects on my Ranger. Unfortunately I’ve had a real issue finding one that will fit mine, as mine is left hand drive and the brake booster takes up all that room.

[@rohanharrison9220]

Cheers for the vids bro I'm gonna install one now 👌🏽

[@selmashikongo3052]

Hi, i have a ford ranger 2.2 2018 and I recently just serviced it at 150 000km. The next day after driving it for about 3km it shut down as i was trying to slow down toward a traffic light. This has now happened 3 times and the diagnostic gave the error code P228D fuel pressure regulator exceed_ fuel pressure too high. I also noticed that that my coolant temperature gauge is just on C and barely moved. Could it be the fuel pressure pump

[@abdautomotive]

sounds like it could be the Fuel Pressure regulator control valve (SCV) , does the car start now?

[@LegitimatelyAxeL]

In a previous video you were saying without an egr the oil can help keep the manifold clean. I was following that idea for a while. Do you suggest a catch can instead now or have I misunderstood?

[@abdautomotive]

depends on your kms & if you have a blanking plate installed.

[@LegitimatelyAxeL]

@abdautomotive it's been professionally removed and cooler has been bypassed

[@abdautomotive]

@@LegitimatelyAxeL in that case you don't need a catch can unless you have high kms

[@JOHN31six]

What is the size of the hose from the intake going to the catch can ?

[@mjossier9127]

Hi, Excuse me sire, but why add a second oil catch can ? Normally, there is already a oil catch can behind the front left wheel. Thanks by advance. Sincerly,

[@AndyL940]

He didn’t put two he just installed it properly. He just had it flopping around

[@AndyL940]

Cheap catch cans are ok unless they block up and pressurise the crank case and make oil piss out of every worn seal

[@abdautomotive]

this one is just a simple straight through design , hence why i used it, i see the expensive ones can block up due to the complex design of them.