Ford Transit Custom 2.0 TDCI Panther 130hp to 170hp with Forscan!

In this clip I will show you how you can increase the power of your Ford Transit Custom vehicle by activating another map that comes in the engine computer - PCM using ELM27 OBD2 adapter and Forscan software available at the following link: forscan.org /
If you found the clip useful, subscribe, like it and support the work of the channel with a donation: paypal.me/work...
Find me on the Workshop385 Forum: workshop385.com/
and on instagram: workshop385_
The video was recorded for informational purposes in good faith. We are not responsible for possible bad outcomes that may occur if you decide to do this on your vehicle. Thank you! :)

[@eisenschmeisser3959]

thanks, gone from 105 to 131 PS using this method. Of course, you can instant realize the change above 2000 rpm....

[@erikski_3615]

Ste dobili moju poruku

[@mjokser5365]

Puno je to za forda 😁😎

[@anfanwu4817]

I measured 0-100KM acceleration in 11.9 seconds ，2021 ford transit custom 6AT 130ps-170ps

[@Workshop385]

Pretty good for Van :)

[@anthonyg87]

You should do a dyno run before andere after!

[@Workshop385]

No Dyno near me... but you can feel difference :)

[@anthonyg87]

@@Workshop385 yes 10nm and 5hp can also be a difference in feeling. Only a dyno wil give hard results

[@mrezniable]

Da si pravi majstor napravio bi to na Ladi 😂😀. Šalim se, no još uvijek ne vjerujem da samo promjeniš tag modela motora. Za većinu vozila, čak za isti ECU i motor postoji ogromna razlika tvorničke i custom mape, a kamoli mape drugog motora. I ja imam auto od 105KS koji su ubijeni nakon diselgate updatea, no auto sad ima već 200000 i ne usudim se petljati sa ičime. Radije se patim "jahanjem mule".

[@Workshop385]

U ovom slučaju se samo promjeni tag motora... sve tvorničke mape su več u ECU-u i samo je potrebno odabrati jaču.

[@TheKawasakiManiac]

1.6 vw?

[@csabatoth370]

Hello dont need a bigger intercooler?..or its working fine?I want in Mondeo 150 ecoblue do it.

[@craigporter-vq9ig]

Mine says Writing blocks failed incompatible configuration any ideas?

[@clintfitzgerald8583]

I will let you all know today if this works for me on my Transit Custom 2.0 130BHP 2018 facelift model😉

[@Workshop385]

I'm happy to hear that. I'm driving like this for 30t km, no problems 😄

[@peterrylander7472]

how did it go??

[@gianlucatoso2930]

hello, I would like to ask you a question, do you know what specifications correspond to the map called 188 panther? I have a Custom 130 CV 2020 but the 170 map does not let me load it. Thanks for the reply

[@ben6453]

Long time ago but we believe the ECU has sectors so to speak so sector 1 105, 2 130 3 is where it gets a bit different if the 170 won't load then use 188. If 170 won't load then panther 188 is 170 if the 170 will load then panther is the 185. Have seen a number of guys do this and get those figures on a Dyno.

[@ben6453]

But very occasionally a 170 won't load so use 188 and it produces 180. And have even seen a few 170s load panther expecting 185 and get 105.

[@johnonyoutube6080]

Did you see any change in fuel consumption after the remap?

[@Workshop385]

it takes maybe a little more... but only reason for that is because I drive it more aggressive. It can also use less fuel if I'm careful with the gas pedal. My consumption is about 8L, but I always have about 800kg in the trunk

[@hihimamnon793]

how about Ford Transist 2.4L TDCI? can you make the video for it

[@GMarinko]

Može se to napraviti i na starijim modelima auta, recimo na Fiat Doblo' 1.9 (Diesel) 2003 godina.

[@Workshop385]

Ovo je samo za Ford vozila...

[@GMarinko]

​@@Workshop385 Znam, nema veze vozit ću i dalje ovog sporog Fiat_a s njegovih 50_tak i konja i nekoliko tovara, tek ima skoro 80 tisuća kilometara ...

[@aleksandar5204]

@@GMarinko nema svrhe raditi na 1.9d motoru jer je on dizel bez turbine, on je oko 65ks? dovoljno mu je to za ono cemu je namenjen, da se tovari :)

[@GMarinko]

@@aleksandar5204 Da točno, nema svrhe bilo što raditi, nije tovarno vozilo jer je ostakljen model "Panorama". Kad je bio nov dobro je vukao i bio je brži nego sada, ali su još pod garancijom u servisu mijenjali t.k.z.v "Bosh" pumpu i nakon toga je postao spor, ide ali mu treba dosta vremena za ubrzanje. U Fiatu kažu "To je takav auto i ne može bolje" ...

[@aleksandar5204]

@@GMarinko mozda pomogne podesavanje pumpe. da li ste probali to?

[@remusstefanalexe5900]

Hi. Do you know if i can do this to a focus mk2 1.6tdci?

[@maxivk5168]

can this be done whit a ford transit custom 2.2tdci 2014? Have forcscan

[@davidc8228]

Zanima me kakva ce potrosnja bit...

[@bokib7659]

Znači sledeći klip popravka turbine.

[@Workshop385]

Ne! 😅

[@mjokser5365]

Kad ne voli opela 😁

[@ivankirola2707]

Pa zašto su ga u tvornici stavili na slabije?

[@janosstrazsi9615]

Transit custom 2.0 echoblue 130PS.2019. Egr, dpf off?

[@stefanristic3436]

Zna li se od koje godine može tako lako da se menja mapa ? Tipa, imam Focus-a mk2 i verujem da to na njemu ne može tako da se uradi. 😢😂

[@Workshop385]

Ne može na Focusu. Koji motor imaš? Na 1.8 TDCI to nije pametno raditi jer se podiže tlak na pumpi goriva i dolazi do ubrzanog trošenja pumpe... krene stvarati opiljke koji začepe dizne i eto belaja. Ja imam 1.8 TDCI i moram reć da mu je 115ks i više nego dovoljno. Imam na kanalu kako staviti tempomat na MK2 :D

[@ikosic]

Jel mogu preko forscana 1.6tdci dignut na 2.0 🤣🤣

[@Workshop385]

Ma e... samo next, next, finish 😂

[@gimlicher]

Pozz da li bi radilo na 2023g 130ks?

[@Workshop385]

Ne znam, dolje je netko napisao da je imao problema prateći ovaj postupak...

[@petrsimonek9658]

It works on my 2023 ford transit l4h3 .

[@chieftain8638]

Pozz da li za taj kombi treba c1 dozvola

[@Workshop385]

Ovo je B kategorija, maksimalna ukupna težina 3.4t, do 3.5t je B kategorija

[@oscararroyofeixas5962]

Hello, just comment that you have to be careful with this modification. In my case I got a failure in the PCM module, with code U2101. The check engine light comes on. To date I have been 3 weeks without van. I have changed the PCM module and formatted to origin and still the same. Still haven't found the solution.... If anyone has encountered the same case and has solved it I would appreciate if you could share. Anyway when I get it solved I will post it in this post. Regards

[@Workshop385]

Ugh... 😞 tell me more about your van, 130hp, year of production? Did you tried to reverse settings?

[@blikez]

Did you get it fixed? And how?

[@oscararroyofeixas5962]

@@blikez Hey, yes a guy solved me this problem reseting all modules from origin.

[@lukamagdic2106]

Ajde za vag grupaciju snimi ako moze sa tim softverom

[@Workshop385]

Ovo je samo za Ford vozila :)

[@antoniozg1210]

Sad se motor manje mući

[@Workshop385]

Ide sad ko raketa... nisam neki od jurnjave, ali volim da je zvijer pod haubom uvijek spremna :)

[@kadamski86]

Trzeba bylo od razu na 250hp...🤣

[@joeyperdok]

LMAO 🤣 well that's not right... As a tuner myself i find it very funny to watch this 😂. Forscan isn't able to change the map of the car. Also changing a map on a car takes longer than that. But very entertaining!

[@Frittestheke]

But you know that Ford has SID212 (Evo) ECU and it is impossible to remap because of encryption? So Power Class change is the way to go 💁🏻‍♂️

[@angelr6772]

??o?o??