Fordson N Manifold

[@martinhambleton5076]

Great video. I am at the moment trying to get a Standard Fordson to run at the moment. New needle/seat and carburettor gasket. It just wants to flood after a couple of clicks on the starting handle.🥵

[@CarlHargreavesRustyRelicsUK]

Hello Have you seated the new needle valve to the new seat ? How I do it is get a small steel ball that will fit into the seat and give it ONE sharp tap with a punch and hammer. Check your float height is correct, to adjust just gently bend the brass arm which attaches the float to the chamber. Hope this may help you out, All the best 👍🏻

[@garyrhodes7089]

good work Carl

[@waynewedlock5976]

Hi very good video. Im at one at the minute. The valves in the inlet ports that let the over fueled fuel leak out arnt one way valves are they i thought that they should be but the let air pass both ways . Where would you advise to get the vapouriser jet and the needle and seat ect . Thanks Wayne

[@CarlHargreavesRustyRelicsUK]

Hello The little brass valves are one way, once cleaned up if you put them in your mouth you should be able to blow through them, but not inhale. They have a small brass flap that can sometimes fall out and make them ineffective. The parts you mention are available at (VTS) vintage tractor spares, or Cotswold vintage tractors. I take it you are in the U.K ?? Parts are more expensive since the covid pandemic. But so is everything else in life. All the best Carl.

[@waynewedlock5976]

@@CarlHargreavesRustyRelicsUK Hi Carl can I remove the flap of the one way valves to clean them how do I clean them just with break cleaner .