Install of Dakota Digital RTX dash at Anderson Ford Motorsports using the Newrad Solutions Digital EZ harness installation kit. 1987 Mustang GT Foxbody.
Пікірлер: 17
@k.c.williams3385 Жыл бұрын
I'm sharing this video with everyone I know.
@warrenkwilson2 ай бұрын
Very useful video, I did the exact install on my 88 Coupe following the video instructions.
@BigJay916 Жыл бұрын
Excellent fellas!! 🎉🎉🎉
@MrStangdawg Жыл бұрын
Thanks so much!
@CarsFoodWeed Жыл бұрын
looks cool. just fixed my speedometer cable on my stock gauges. next time it breaks I'll probably look into a modern solution.
@MrStangdawg Жыл бұрын
That's what's nice about the digital dash, no more speedometer cable.
@thefoxlife34314 күн бұрын
Did you have to do anything different in the wiring since you have a Terminator X installed already? Any specific changes so all gauges work with Term X and DD dash?
@Baddeal4 ай бұрын
I’m running a one wire alternator so the resistor wouldn’t be needed? It is ran straight to the battery. I wouldn’t think it matters.
@MrStangdawg4 ай бұрын
correct resistor only needed for 2G (87-93) or 3G alternator. 1G alternator (79-86) will not need the resistor unless it's been upgraded
@seeunow44Ай бұрын
Why not show speed sensor /gps?
@CarsFoodWeed Жыл бұрын
is there a way to change the backlight to green instead of white?
@MrStangdawg Жыл бұрын
Yes it has a whole menu for setting the backlight and needle colors. You enter into the "lighting" setting.
@heathermedd683 Жыл бұрын
Is the 510 ohm resister required when doing a coyote swap, with a Ford control pack, or PBH control pack?
@MrStangdawg Жыл бұрын
You will not need it when doing a Coyote. Most likely you are using a 2011 and UP alternator and should be a plug in your harness to connect to it.