How to use satellite subsets in Trimble Access

[@robertlennox2414]

It seems to me that you would make your first measurement with all of the SV's enabled, and then QC the position with a each subset solutions. This QC is specifically to address multipath errors. The general theory is that if you have a multipath solution, the subsequent subset solutions with SV's in a different orientation will produce a different solution thus confirming a multipath error. It's the same theory of re-observing the point with a time separation. Contrarily, if the three positions agree, the solution is devoid of a multipath solution.

[@neilrobicheau6228]

EDELBROCK!!!! Good job buddy.

[@rogelioservin8221]

are the results different than just turning satellites off and on again?