Turbo 14 great video. Will be looking forward to future videos.
@bandolero6968 Жыл бұрын
Nice video ! I need help. I’m planing to stretch kw to 298” but idk what to do about the drive shaft !!? Any ideas ?
@cesarpolanco92492 жыл бұрын
How you doing? In what state are you located? I want to stretch my freightliner Columbia.
@turbo14382 жыл бұрын
I'm in Maine.
@waheeddawodu98922 жыл бұрын
How long does it take to start n finish the stretching? I want to stretch a 26ft box truck in order to add a 3-4ft space for bed (Sleeper).
@lockeM140 Жыл бұрын
Bottle Jack's dont look safe
@turbo1438 Жыл бұрын
Yes it was sketchy there for a minute. Probably should have tightened up my wheel chocks a bit. Thanks for watching and commenting.
@bandolero6968 Жыл бұрын
Nice video ! I need help. I’m planing to stretch kw to 298” but idk what to do about the drive shaft !!? Any ideas ?
@turbo1438 Жыл бұрын
Thanks. I usually start by determining the overall measurement you will be lengthening your wheelbase, this will be what you'll need to add to the drive line. Most often this means a new shaft section of this length (with a additional center bearing) placed between the original two (or three) sections of drive shaft. Hopes this helps, good luck.
@bandolero6968 Жыл бұрын
@@turbo1438 nice ! Thank you for your response. That sums up a lot . I’m going with a 298 for the w9 . The the short drive shaft go to trans then to existing or original first ? Might dumb question I guess but idk bout torque affecting anything. Ty!
@turbo1438 Жыл бұрын
@@bandolero6968 I wouldn't worry about tourqe inputs, I generally try to do as little modification to the very front shaft from trans. Usually u end up adding a cross member/s and that is where I try to put the additional shaft and center bearing.
@turbo1438 Жыл бұрын
@@bandolero6968 kzbin.info/www/bejne/oqmVkKGpftKEirc This video shows a better example