Free And Easy Exhaust Mod For Your Aprilia Tuono V4 - Make It Sound Amazing In Under 5 Minutes!

[@Budget-Cars-And-Bikes]

SUPER QUICK AND EASY EXHAUST MODIFICATION FOR THE APRILIA 1000cc V4 BIKES - DON'T FORGET TO SUBSCRIBE!

[@allthatglitterz4564]

I do love free mods 😂

[@Budget-Cars-And-Bikes]

Me Too! and this was so simple, nothing to cut or bend, just 4 nuts to remove 😁

[@allthatglitterz4564]

@@Budget-Cars-And-Bikes Good Job Mate 😉👍😁

[@Budget-Cars-And-Bikes]

@@allthatglitterz4564 Cheers Fella 🤗

[@CostelloPlays]

👍🙂

[@catalin1588]

Nice one boss, but why won't you rev it a bit for God's sake... was waiting for it the whole video and nothing happened...

[@Budget-Cars-And-Bikes]

Plan was to get it revved on the1st part of this video, but as you can tell the 1st part cut off early, that's because the battery on the camera ran out during filming! totally my fault and a shame, but hopefully it's still helpful 😁

[@bltzbrg]

There is an even easier solution

[@Budget-Cars-And-Bikes]

@@bltzbrg Easier than 2 bolts???

[@bltzbrg]

@@Budget-Cars-And-Bikes You said you need to remove the bottom covers and remove the bowden cable from the back as well. You can easily open the flap motor housing, unscrew the plate that holds the bowden cables, remove the bowden cables, screw the plate back on, leave the cables there, reassemble the housing. So the easiest is 3 screws. If I am not wrong you did some more screws :)

[@Budget-Cars-And-Bikes]

@@bltzbrg yes I get that, but from talking with Aprilia tech guys, it's better to totally remove the cables, and there have been reports of them getting tangled after just unfixing them at one end, and leaving them in there.

[@bltzbrg]

@@Budget-Cars-And-Bikes oh ok. I will keep an eye on that