Freewing 80mm Avanti Build Overview

[@andycraig8610]

Thanks a lot, built mine today, found your video very helpful. Andy in uk.

[@TomFYouTube]

Thanks for the video. I just received my Avanti S from MotionRC and it is my first foamy and EDF. Been flying RC for 38yrs but always scoffed at foamies but the Freewing EDFs are very nice especially the A-10 which I also ordered. I will be adding the 3D printed front landing gear brace and printed NACA ducts as well as a couple Nerf whistles in the next day or two. I will add the extras before I add the tail feathers. to prevent damage to them. I will also install the pushrods with the wings off after centering the aileron servo and adjusting the flap servo to avoid dimples or damage to the airframe.

[@jerrymr806]

Excellent....tks for the helpful tips....got mine today and doing the build now....!!!!!!

[@onapproachrc5471]

Do you recommend this edf for a first jet lots of stick time here but never had a jet any advise?

[@anthonythompson4718]

awesome job i think i will buy this jet.

[@leifpernstig3200]

Thanks for the video. My AvantiS 80 mm (yellow) soon ready for takeoff but how do I calibrate the ESC? Is it the usual stuff "Full throttle>connect battery>beep-beep>zero throttle"?

[@neomayad]

did anyone else have trouble with the split flaps working in opposites. im using a spektrum ix12

[@Mindcoach1on1]

any room for a 12 s setup in there

[@REDSRADIOCONTROL]

+Mike D im afriad not i have my 6s5000 pushed all the way back anyway just to get the cg right

[@Mindcoach1on1]

ok thank you..