Front Brakes 2013 Can AM Spyder RS-S new pads replacement How to

[@phillipwebster4041]

Just an FYI to others looking at this video, I have a 2011 RS and it does not use the Brembo caliper and thus the pad and pins arrangement is different. The pads on the older bikes use a wire hook arrangement to secure the pads to the calipers. I'd never seen anything like it before but it was pretty easy to figure out. I was all ready to take out a pin like shown in the video but instead a little gentle prying with a screwdriver and the popped right out. New ones go back in with a resounding "click" so you know they are seated correctly. All that said, I still found this video helpful and appreciate you putting it out there.

[@lmiller4121]

I am so glad that you mentioned it is IMPERATIVE THAT YOU PUMP THE BRAKES AFTER INSTALL BEGORE MOVING.

[@ES44AC-2]

Thanks for the video. Next time I change mine I'm going to do it my self. I do all my other vehicles. I have a 2015 RTS.

[@mikehall7806]

Can you make a video for the rear pads. They are different and much harder to get to? Thanks, Mike

[@frankyounger231]

thanks for the video Jason ! got a question , the metric bolt you took out , then the spring , then the pads , ----> the bolt , I saw you put it in on the opposite side , than the side you took it off , ( took it off on the right side , put it on the left side ) , are there threads on both sides of the brake caliper housing , to allow for left or right assembly ?

[@sallepe83]

Came to ask the same question

[@williamviehland1860]

are the back brakes easy to change

[@q-bert6454]

Back already? Short ride

[@azizelmalahi9128]

Where did you get the Front spoiler?

[@q-bert6454]

Aziz El Malahi at the front spoiler shop. 🤡🤡

[@azizelmalahi9128]

@@q-bert6454 okay..... Do you have a Website or something for me?