Furitek Grasshopper Brushless System for the Losi Micro B.

[@VS666]

what receiver did you end up using with the flysky? do the furitek receivers work? i have an extra avatar i'm not using, i dont think the flysky receiver will fit haha

[@RunThatRC]

I used a flysky receiver with gyro. Had to decase it to fit. If you want to use the transmitter it came with the SLR300 spektrum receiver should fit with it decased as well.

[@xXYannuschXx]

Mind boggling that this tiny Brushless setup is sensored. I hope they release a Truggy version some day; have a original 1/36 Micro T sitting on my shelf.

[@RunThatRC]

Hopefully they continue releasing micro bashers.

[@GSG-lc5zm]

😂🤣😂🤣😂 The title on KZbin reads Furitek Gr asshoppe... I said what !? Lmfao 🤣

[@RunThatRC]

😮😅

[@Lucky15edc]

I used a spectrum slr300. Binds up easily with the stock transmitter and only cost $25 on Amazon. Just need to remove the case to make it a little smaller and you’re good to go

[@basssmashin1875]

What receiver did you use for it , I'm looking to do the same thing .

[@RunThatRC]

you could use a flysky micro receiver. Maybe even a slr300 receiver to work with the stock transmitter. I dont have a slr300 but I heard taking it out the case makes it fit.

[@User3eighty4]

I wanna run the furitek motor with a hobbywing esc that has software that works correctly do they make that sensor wire?

[@RunThatRC]

I haven't looked but if both ends of the Furitek are the same connector then you can use the included adapter cable to run a hobbywing esc on this motor.

[@LowRC85]

show it running!!! why do this whole video and not show us it running? lame

[@RunThatRC]

Look up my playlist my first video on this Micro B is it running with all my upgrades.

[@davidmichael90]

Why dont you show it running? Hate it

[@RunThatRC]

If you look at my micro b playlist I already have a video out on it running. I need to adjust the links for a better alignment since I just threw them on without actually measuring the lengths.