Ganti IR remote dengan DIY IR Blaster! ESP8266 Blynk Smart Home

[@easthulk99]

terbaik...

[@easthulk99]

kalau ubah suhu guna remote aircond yg asal bertukar tak status kat blynk app tuu???😁😁😁

[@badral-moraggab2898]

Thank you sooo much. I spent long time to know it until I watched your video. you explained on the best way. But because I don't understand (Indonesian, Malay) language I didn't understand the last part of your video which is for what you connected A0 of the ESP8266 to the A/C. What is the benefit of this connecting. please I need help on this. Thanks ^_^.

[@rexio51]

Hi bro, A0 goes to the ‘power’ LED of the A/C board, find a pin that gives you ‘high’ volt reading when A/C is ON, and ‘low’ reading when A/C is OFF. This is the pin that you want to connect to A0. If the voltage during ‘high’/ON exceeds the max input voltage of your microcontroller/mcu, you need to put suitable resistor in order to not burn your microcontrollwr/mcu! HTH

[@harez93]

terbaik bro ! boleh tiru idea guna 5vdc dekat aircond tu untuk power up nodemcu xD pakai esp-01 boleh kan ni bro?

[@rexio51]

Boleh bro... make sure 5vdc ye.. 😅

[@mbj78]

terbaik bro.. main dgn arduino lagi.. sempoi...

[@rexio51]

Thanks brooo...!

[@sherina.hussin2638]

👍🏼👍🏼👍🏼