GEM Remote Control "LEVEL" Switch Operation on Hi Tide Boat Lift

[@SeaDog2952]

These GEM operation videos are very helpful. Nice job.

[@SAPBOBJ40]

Life saver! I was about to start taking cables apart! Thanks for this awesome video!

[@chesapeake_boat_lifts]

Glad it helped!

[@chesapeake_boat_lifts]

Thank you, glad it helped!

[@blaster-zy7xx]

just FYI, my lift was always getting out of level and I discovered that the pulley wheel on the cradle was stuck and the cable was cutting into the stuck pully, slowing it down and knocking it out of level. Replacing the stuck pulley wheel fixed and now it stays level.

[@1on1internetmarketing]

Thank you my lift is now level no more water pooling on one side!!!!

[@chesapeake_boat_lifts]

Glad to help 😊

[@chrismagory9423]

Can you also do the front of the boat with the lever switch. Will this effect the limit switch

[@chesapeake_boat_lifts]

Hi Chris, no, not with this particular style of lift. The fore / aft pitch is determined and adjust by cable lengths.

[@chrismagory9423]

@@chesapeake_boat_lifts I have a elevator lift and the rear or stern is lower than the front

[@chesapeake_boat_lifts]

Then yes, you should be able to raise the stern with the leveling switch . Be mindful though, elevator lifts do not like to be run particularly out of level they work best when flat so try to keep it as flat as possible, while still allowing water to drain aft.

[@jpmcdonough9067]

I can get either the bow or stern level from side to side, but not both. In other words only one of the "corners" is not level. How do I fix that? Thanks

[@chesapeake_boat_lifts]

Hard to say without seeing it, but there’s a very good chance your cables need to be rewrapped or adjusted (assuming it’s a lift of this style depicted in the video)

[@Bernardo2363]

Thanks for sharing!

[@chesapeake_boat_lifts]

You bet!

[@reelnative01]

Most people with two controls never have this problem