Gibson Les Paul Junior DC Build - Part 14 - Final Touches

[@tylerjarrett981]

I wanna hear it! It looks so good!

[@BecoMendes]

@MosalGuitars, What would you recommend doing if someone were to mishandle the neck angle? What would you use to unfasten the Titebond adhesive and rectify the angle? I'm asking for a friend... :)

[@MosalGuitars]

I would try some steam and a thin pallet knife. A wall paper steamer with a damp cloth and using the knife to try and get some of the moisture down between the joint should start to loosen things up. The best of luck!

[@janoshtrenhem3573]

Do You insulate the pick up and electronics pockets at all ? Or is it not necessary if you have a ground wire on the bridge ? BR

[@MosalGuitars]

Shielding paint in the pickup and control cavities is required to minimise noise and a ground wire to the bridge is also necessary

[@landonminton9264]

What size drill bit did you use for the holes to the bridge

[@MosalGuitars]

For this bridge the posts needed 11.5mm drill holes. But this varies between bridges. The best way is the measure the posts you have and go down 0.5mm smaller for a tight fit