Big thanks for taking the time to clearly explain this process. The other videos I’ve watched have been confusing.
@e.s.l5861 Жыл бұрын
This is the best tutorial I have found for this procedure
@themildgoose Жыл бұрын
Extremely informational on this, I did my first cam on a gen 4 6.0L and the pushrods were doing my head in with the ticking and not knowing the base circle had changed. Big thank you from a dumb ass trying to get his engine right, and extra points on background tracks!
@alexanderknight77932 жыл бұрын
Great video, I like that you described it clearly in both methods.
@GODSPEEDGarage Жыл бұрын
Thank you!
@julz59155 ай бұрын
Hopefully I can figure this out now
@ralphfreeman2552 жыл бұрын
About to build my LS swap and appreciate the video!
@musketballmatt6773Ай бұрын
When checking measurement do you tighten all the way down or just finger tight
@normajorge9906Ай бұрын
Do i need to check all 16 when using johnsons lifters? And when checking for exhaust valve do i turn the motor clock wise also until the intake rocker goes down??
@RFrizzell Жыл бұрын
Great stuff Brother!!!! Thanks!!!
@fladrummer12 жыл бұрын
Thanks for the info building a 6O in a C5 Texas Speed heads has been a nightmare 7.4 push rods but dont think the mechanic did the math or put the pushrods on the small lobe of the cam going to a performance shop today......
@brianhaw93982 жыл бұрын
Thanks,some good info.
@Robert-uc5pb10 ай бұрын
I'm doing a head gasket job on an 07 Yukon Denali 6.2l. I got the heads on and now I'm doing the Rocker arms. I noticed when I'm torquing the arms some of the rockers slide from the center of the valve stem and moves closer to the edge of the spring. My valve springs are slightly compressed also when I finish torquing to 22 ft lbs. Can you tell me what can be the problem? I'm stumped
@Jason-ht6ze2 ай бұрын
🔥
@marcogonzalez74092 жыл бұрын
Really helpful video 👌
@GODSPEEDGarage2 жыл бұрын
Glad it was helpful!
@Weinhoffercustoms Жыл бұрын
I always torque the Fastner to spec then check for zero lash
@Abraham_R_ Жыл бұрын
1st time measuring pushrod length here, but I have a question see if anyone could give me advice, I basically did everything like he did on the video even the math but with my measurements, so my intake is 7.2875 rounded it to 7.300 and my exhaust is 7.325, should I buy all the pushrods 7.325 or should I buy half and half?
@chazdunaway82402 жыл бұрын
did you add pre load to you length or did i miss it?
@Recklessfireblade2 жыл бұрын
Yes you add it to whatever preload you need. Most lifters such as Johnson lifters will have a specific preload on the box. GM lifters have a much broader range and are more forgiving
@GODSPEEDGarage2 жыл бұрын
yes. for the first method you have to add it. the second method (the turn method) accounts for the pre-load. I second what @Brandon Ouzts said - GM lifters have a really broad range. as long as you're in that range you're good. hope that helps!