Golf MK4 Dashboard + Arduino + Simhub

[@charlesingram9471]

You da man! I will so be teaching myself to do this!

[@totolaricos9629]

How do you do that ? Do you have a wiring schema

[@stuntro70bydrd35]

hello what and the pin for the rev counter and the fuel gauge on the golf 4 meter thank you

[@MrDJTomixXx]

1 - Terminal 152 - Brake pad wear 3 - Tachometer output 14 - not occupied5 - Tank sensor 6 - Tank warning OBD 27 - Terminal 31 (sensor Ground (GND))8 - Coolant temperature9 - Terminal 31 (load Ground (GND))10 - Oil pressure 2 (high)11 - RPM signal12 - A/C shut-off 13 - E-Gas/glow plug control14 - Level control15 - Terminal 58d16 - Trailer turn signal17 - High beam18 - Left turn signal19 - not occupied20 - Terminal 58s21 - Driver door contact22 - Low coolant23 - Terminal 3024 - Terminal 31 (load Ground (GND))25 - Consumption signal26 - Right parking light27 - Left parking light28 - Tachometer input29 - Brake30 - S-contact31 - Tachometer output 232 - ESP/ASR

[@Griddens]

Hey bud did you ever figure out how to fix the speedo issue where it jumps back sometimes? have this issue with lancer, subaru , and a few others. that are not can bus. ?

[@ReynoldsTV]

Can you do honda civic ek ?

[@cobra3392]

Hello looking for some info as I'm a noob to the cluster wiring. Would pay you for your time, thanks man!

[@joelcigaba1376]

How you connect dashboard to arduino

[@huangwen760]

Hey headshotsam, may i have your wiring connection method, dashboard pinout number and arduino NANO/MEGA2560 PIN number.

[@cobra3392]

Is this a canbus or noncanbus cluster?

[@headshotsam]

This cluster has canbus but you do not need it. It is the green connector. You need the blue one. All signals are pwm

[@cobra3392]

Would you be able to send me a wiring schematic to [e-mail]? Otherwise just set up with simhub? I have a 2006 mk4 jetta cluster and I spose am a little confused on the wiring setup. Would appreciate it extremely and could also send you pics of the setup and everything. I'm sure I just have the wiring wrong. I have 12v power to the cluster and it illuminates fine but my gauge wiring I think is wrong. Thanks immensely man this project started earlier this year and this is the last piece of the puzzle:D

[@cobra3392]

I use pins for 12v positive, 5 for fuel, 11 for rpm tach, 20 for illumination, 24 ground, 28 for speedometer tach for the blue terminal. For the green 18 for temp. I'm an idiot and dont understand how to bridge to get the rest of the lights to turn off either, do you bridge them to the ground? Would be happy to pay you for your time, I'm just really excited someone's done this exact cluster before :)

[@cobra3392]

Exact wiring as github.com/SHWotever/SimHub/wiki/Arduino-After-Market-Tach-support and github.com/SHWotever/SimHub/wiki/BMW-E36-Cluster-Setup just not sure what I'm doing wrong. Thanks for your insight so much, whatever you need just ask as this would make a dream come true! :)

[@jarrodcovers74]

Hello i have the same cluster like on video, do you have schematic or something? Thanks

[@takaraxa5046]

tutorial plis

[@frankbob4043]

You cannot drive.