Golf7 Virtual DASH Key Programming - No more waiting for Immo Data or ordering from the Dealer!!

[@SpringvisualTk]

Thanks for the video, I think you mean IMMO-Data in the title, Sync is received from the original key.

[@Remkeys]

Yes, you are right!

[@WheepyMAW]

If you have one working key yes ! If it’s AKL, you can read cluster on table, then need to wait for sync data

[@jonyovanno4145]

Did you have to put the capacitor back on the board???

[@labrugola4365]

hopefully 5c soon too

[@outofthisworld8037]

Gotta get down 5a first before they're able to do 5c

[@labrugola4365]

@outofthisworld8037 dear this is 5a system.... 5c is mqb49

[@clavisclavis]

Does the new key need to be original factory key or can it be an aftermarket precoded remote?

[@Remkeys]

you can use aftermarket, original blank or generated key by KYDZ Stone, Keydiy, Xhorse, Autel..no limit!!!

[@clavisclavis]

@@Remkeys Amazing, is it possible to buy only the pcb and coil reader seperatley or do you need to buy the programmer as well? Meaning is this an add-on for the MLB 5M programmer?

[@piotrkacprzak2861]

​@@RemkeysHi. Are you 100% sure about that we can use Xhorse keys or any other universal mqb? Because manufacturer says cannot use xhorse keys and must use OEM or aftermarket.

[@GOMAND-keys4you]

brawo

[@simonmg6797]

Obviously MQB48 not 49 🤔

[@autoschluessel_hamburg]

Das auslöten und einlöten ist ein echtes Problem, machst Du da etwas falsch geht nichts mehr. Der Widerstand ist sehr klein, gefährlich

[@Remkeys]

Uberhaupt kein problem, ZERO RISK!!!

[@erdbeeren3901]

Even if you broke the original key you have immo data and can retrieve sync data and program 2new keys, problem solved

[@CarKeyGuyNL]

If you don't trust your own soldering skills, don't do the job!

[@piotrkacprzak2861]

In this video, you only remove capacitor instead of replacing it with anither one (included in set) like the manual says. Not sure why, if it worled then good but would be better to follow instructions because its kinda misleading

[@Giuseppe-ts6bk]

Remove the capacitor Before read Key, and replacing after Reading with new capacitor

[@piotrkacprzak2861]

@@Giuseppe-ts6bk nooo. That doesnt make sense. Look at the software instruction. It clearly tells you to replace it with temporary capacitor (for reading data). What would be the point to replace fully working original capacitor for another one AFTER reading. Today I made a key with this tool as per what I understand is right and everything was... Just right :)

[@Giuseppe-ts6bk]

@@piotrkacprzak2861 My mistake, however just put the capacitor back after reading. I expressed myself badly. I made a key today, and if you don't put the capacitor back the remote control won't work.

[@piotrkacprzak2861]

​@@Giuseppe-ts6bkthats nice it worked, however it clearly says to replace it, not only remove. Look at 2:06 mark on this video and read test above wiring diagram.

[@ΒασίληςΥφαντής-ε9ν]

I don't get the point of removing the capacitor and replacing it with a new one i guess is lower pf??