Graphene-X sizing

A brief tutorial on how to measure and choose the right fit for your Graphene-X Alpha Series Jacket

[@UFOSPACEMAN]

Thank you this is very helpful!

[@Nagamiji]

Thnx for the video, it makes sizing very clear. Just look forward to my Graphenes

[@jorgebarros2274]

Thanks Naga!!! Glad it was clear enough!!

[@theasiamtmgroup]

Thanks for this. I've been wondering about the sizing for layering options. I'm hoping we can get the jackets as soon as possible because in March I'm planning to do a solo West Highlands Way hike in Scotland which is a 96 mile hike and given that it'll be the beginning of Spring, will be sure to be super wet and windy. It's going to be a proper test of the jacket. Too bad you won't have the bottoms (yet).

[@jorgebarros2274]

Hi Andrew, we will do every possible thing to have the jackets shipped ASAP. We are on it! Thanks for your support!

[@fredericmenges]

why only inches and no cm? ;( is there any way you could add the cm also in the video? Would very gladly appreciate it. And I am VERY looking forward your jacket. Very very nice campaign.

[@secdeal]

measure cm then divide by 2.54..

[@jorgebarros2274]

Hi Frederic! We can't further edit the video sadly but in the campaign page you can find the equivalent of centimeters to inches. Thanks a lot for your support, incredibly proud after your comment. Thanks!

[@Neverlan33]

What are the correspondences of the measurements obtained with the sizes (S, M, L, LX .........)?

[@jfr72]

Hi Jorge, thanks for these explanations. You give the measurements for S and L. Could you give them for L also ? I'm not sure yet about the sizing. Thanks !

[@cokebarros]

Hi! I think you mean M right? Sadly today we don't have any M sizes with us. Nevertheless following the same instructions as here you'll be able to define yours according to your preferred fit.

[@jfr72]

@@cokebarros thanks! Yes, I meant M. Typo. I saw that size M existed on indiegogo. That's why I asked. I will try to figure it out. Thanks again for answering

[@Hello-eh1iy]

So what happens after we wash the jacket 20x? Does the waterproofing ability disappear? Do we have to reapply the coating?

[@cokebarros]

Hi! After a lot of washes you could expect the coating to wash away. This coating is not what gives the jacket the waterproofness though (is the TPU or middle layer what does). The coating gives the water repellent properties and yes, you can re-apply if you want. Hope this helps!

[@Hello-eh1iy]

Wow thanks for the fast response. Ok i will think about it then. I was hoping the repellent would be forever. I dont know much about jackets and repellents sorry.

[@cokebarros]

@@Hello-eh1iy Happy to help John! There are no permanent coatings actually and this one is probably one of the longest performing on the market, and besides it's PFC free, so no chemicals involved. Hope to have you in! Have an awesome day!

[@corderoak]

@@cokebarros Hi, how do you reapply the coating? Are instructions provided with the jacket? Thanks.

[@cokebarros]

@@corderoak Here you can find a video were re-applying is well explained. We recommend to use PFC free coatings. Nwvertheless, note that the Eco-Bionic that comes in the jacket should last for a good while. Here the link to the video: kzbin.info/www/bejne/m6bFaIdmjtOSr6M