This video is exactly what I needed. Will be using this for the reverse wiring for my manual swapped GS300. Also has BMW 6speed ZF gearbox (from E46.)
@JeromeArcher-rd4ws4 ай бұрын
Hey bro I’m about to pick up an 01 here in a few days and I appreciate this video this has me hyped
@lakaies174 Жыл бұрын
My dude, thank you for the reverse lights wiring, also very good to know about the Wilwood cylinder, but from my research it says that the E9x slave cylinder and CMC bore is 3/4"? I see you're using a stainless steel clutch line, which one did you use to fit the CMC to the ZF slave cylinder?
@EdsonHenry Жыл бұрын
Appreciate this video. I have one question. Did you have to run an AUTO to Manual Module so the car can run with the stock ecu?
@BoBuilds7 ай бұрын
No it ran perfect fine for me
@OhToeKnee5 ай бұрын
thinking of doing this to my gte single turbo stock ecu gs300 wondering if it runs just fine with stock ecu at WOT with just jumping the neutral switch wires.
@jaguvaari Жыл бұрын
Hi, in your previous post you mentioned/ revealed the gearbox rattle issue....and to do something to eliminate it.... I have a 71 Mustang with a 429 V8 making ab. 650 hp/750 Nm and having a Tilton 3 disc rigid discs and a lightened steel flywheel on the engine side and after the gearbox GS6 53DZ I have rigid steel flange and a prop shaft with longitudinal movement to eliminate the rigid rear axle movement. After installing the gearbox I noticed the same gearbox rattle as you had. Did you do something to cure the rattle and what actually is the reason for the rattle. You comment would be highly appreciated. I also invite others to comment this issue which is. a bit embarrassing as it sounds unhealthy although the gearbox otherwise works completely fine.
@UninhibitedAuto5 ай бұрын
Which zf transmission did you use??
@liamcooke5513 Жыл бұрын
Hey mate, did you end up doing something with the handbrake? Im looking at doing this swap in the future and the handbrake is my only concern
@BoBuilds Жыл бұрын
i got an E brake handle from an 06 mustang from Amazon. work fine with the original e brake cable
@BoBuilds Жыл бұрын
just had to reroute the cable and i mounted the e brake handle on the driver side of center console
@CormacHD-j7w8 ай бұрын
Did you get that trans mount somewhere or did you make it?
@BoBuilds7 ай бұрын
It’s from Collins adapters
@jbjdmcruiser237 ай бұрын
Question tho, will you accept another customer? I need mine to be done.
@BoBuilds7 ай бұрын
Where are you located
@ChefNorrawitJ Жыл бұрын
Hey Bo , do you have the part # for the willwood master cylinder
@ORCChannel Жыл бұрын
Can you write full code of this gearbox because bmw have so many zf gearboxes
@BoBuilds Жыл бұрын
GS6-37bz
@ORCChannel Жыл бұрын
@@BoBuilds thanks
@dannyrodriguez63969 ай бұрын
What driveshaft are you running from the trans to diff
@BoBuilds7 ай бұрын
Telescoping 54” steel shaft, custom made
@josevaldez7281 Жыл бұрын
What converter you running in the truck Norris 5.3