GT2 TIMING PULLEY | FUSION 360 TUTORIAL

[@j33pguy]

Thank you for your hard work, these videos are great!!! Keep up the good work.

[@daxmakes]

Thank you, Muammar! It's great to learn by watching someone so proficient with F360. :)

[@josephclifford3297]

Super fast, straight to it. Nice.

[@piotrwyrw]

Where did you get the dimensions from?

[@shivamchaurasiya1716]

Pls upload video drone structure and different defferent simulation parameters pls

[@leonsplaylife]

Couldnt locate the insert. What is the part number?

[@arnabdasgupta5695]

Nice Video

[@gonzalodutrasilva]

Hello how are you, I loved your video, but I have a problem, where do you get the 0.195mm? Thank you very much. Hola como estas, me encanto tu video, pero tengo un problema, de donde obtienes el 0.195mm? Muchas gracias

[@SPARKPLUG98]

Please tell me time stamp

[@gonzalodutrasilva]

@@SPARKPLUG98 In 1:50

[@SPARKPLUG98]

It's just a distance , it is as it is

[@MANCHILDMD2020]

It looks like it is the total depth of the tooth minus the radius of the tooth. .75-.555+.195 this gives the off set placement of the tooth center below the OD of the drive pulley. From the GT2 schematic

[@aman72kamboj]

tks

[@maikelnaranjo109]

Good video, but you are going to fast, and most of the command cn't be understood, you need to slow down for those that don't know most of this stuff.

[@joeyn.8379]

too fast and not exactly worked and described by the scrub screw