In which I try to save my airless Digital Tyre Inflator, badly. To be honest, its a bit dull. Best give it a miss and go stop raw sewage being poured into our rivers instead.
Пікірлер: 7
@JimF5006 ай бұрын
The screw in type of valve connection is good for the fact that it stays on, and you won't push it in too far,the downside is that if you are not fast enough or the threads on the valve are dirty, you loose alot of air so you have to overinflate it to allow for this.
@sleepycatpictures11766 ай бұрын
Yes, spot on!
@landroverman796 ай бұрын
If you haven't tipped it and chopped the plug off, could you of tried the larger o ring then a smaller one inside the bigger one. Nice to see the videos again and your both doing well. I'm chasing an annoying squeak from the engine bay or underneath. Few people have said to grease the prop shafts (never done them so a first for me) and also check the wheel bearings. So fingers crossed it's just props. 😅
@sleepycatpictures11766 ай бұрын
@@landroverman79 Mm, didn't think of that. Too late now, I needed the plug for something else. I highly recommend greasing the prop shafts. It's a tawse of a job unless you have a four post lift, otherwise you have to get the prop shaft nipples in the right place when you are underneath. I think I've covered it somewhere. One of the nipple holes is blanked off, remove the plug, (allen key I think) and insert nipple. It has to be done, because if the front shaft let's go . . .