Handheld Router Basics

Handheld routers can add so much to your woodworking and your shop, but it’s very important that you use them correctly. Routers run at a very high rpm and, of course, they’re used with very sharp bits, so can be dangerous if used incorrectly.
Get new woodworking videos, articles, and projects every week with the free WWGOA newsletter. Sign up today! bit.ly/3H3BzvC
Buying advice
The router used in the video, a fixed base router, is one that allows you to set the router bit’s depth of cut and lock the router base with the bit in that position. Look for a router that provides ¼” and ½” collets. Variable speed is very important so that as you change router bits you can adjust the speed. Use this router bit speed chart as an rpm guide. drive.google.c...
Edge profile
You can dress up edges on your projects with profile router bits. Pay attention to feed direction to make sure you’re not climb cutting, and make sure you start and stop the router correctly. A router pad prevents your material from sliding around the workbench while you’re working on it. The bearing on the router bit controls the lateral depth of cut, the router controls vertical depth of cut.
Cutting dadoes
An easy to make shop-made jig makes cutting dadoes dirt simple. In addition to being perfect for dadoes the jig can be used to trim large panels to final size. Follow the directions for making the jig so it’s customized for your router., and you’ll be ready to use it on your next project.
Self-releasing collets
Another great feature to look for on routers is a self-releasing collet. They greatly simplify removing bits from your router.
Sign up for the free WWGOA newsletter to receive the latest videos, articles, and tips straight from the experts! 🔨 bit.ly/3H3BzvC
🔨 Learn more on the WWGOA website: www.wwgoa.com

[@robertmcevoy24]

Thanks George you have a gift of teaching, the jig is going to be a big help using my router.

[@214rwoz]

Thank you for your time and effort.

[@devojohnston420]

I’m confused,, you said go left to right but you went right to left on the back side. ?? Sorry, watched it again, you said counterclockwise, but isn’t going right to left on the back the same as going right to left on the front? Totally newbie here. Love your videos. They are helping me tremendously.

[@KodiakCO]

Very helpful video, thank you!

[@BlownUpp]

What does it mean when the bit tries jumping while you're making a cut? Is that a symptom of going to deep?

[@bvb8769]

I don't see the speed chart referenced at 2:20 in the video. Thanks for the video.

[@Burnsian85]

There's no chart link

[@rickkinney1249]

are those bessey clamps with something added to use in bench holes?? thanx rick

[@emilevoyer123]

THANKS FOR THE VIDEO

[@janetgorelick]

If you put the dado guide on the line, isn't the dado going to be to the left of the line rather than down the middle?

[@architennis]

Yes, that's the idea. Figure out where one edge of the dado should be and draw your line there.