Harley Front Fork Seal Replacement 39MM How To Part 1

[@garycb8592]

Following. Good to see you back with the Sportster.

[@motorcycleridingandrepair1627]

Thank you Gary! I took your advise and I am going to try to get back with some more uploads with the HD's! Thank you for sticking around!

[@danielkifaya4150]

I took your advice and took out the washer from the right tube top, and added a spacer on the left side as in your video too... along with the same Chinese knock off stabilizer and I can say I’m really thrilled with the results. Only problem I had is the entire setup leaked again so I watched another video and did it right. But good job bro!

[@motorcycleridingandrepair1627]

Hey Daniel I missed your comment and just saw it. Thank you for watching. I hope it all worked out for you. One thing can oftentimes lead to another but if you keep after if you can usually make it work! Thanks for your comment!

[@philipmceachern426]

It'd been great if you could've shown the actual visual taking the seal out.

[@cognitivedissonance7539]

he did a great 1/4 of a job.

[@Salvatore3333]

My sportster was 883 and was converted to 1200 THUNDER PERFORMANCE cause when i was doing it there were loads of thunders and storms ahhhhhh

[@PkwyDrive13]

Why are your Memphis shades fairing mounts on backwards? Unless for some reason they're supposed to be.. My fairing mounts / directions show them the opposite way..

[@mikeez5455]

1200 gets about 70 hp