Heretic Labs Tank Grip Installation - What The Tech!

[@титанбравла]

Thank you for that video! I bought this regulator and soon will try to install it.

[@LiveFreeOrRIP]

could this work with an AEG Jack conversion. I have a AMAZING jack set up but i want to run on gun bottles.

[@therealnicenick]

Nice!

[@imaginexist]

for the article 2 if i set the screws for the adjustment trigger i need to disassemble the grip as well in order to remove the upper?

[@MrAdamgw1]

SPEEDSOFTERS intensifies!

[@Jason199985353746496]

I try to tune the psi to 120 or above but found out even how hard I turn the regulator, the highest it can go is 110, may I ask what maybe the problem? Thanks

[@alexanderestk]

I installed this on my heretic labs article 1. Right after installation my inferno is now shooting air out of the nozzle. I tried re lubing everything but nothing is working. I suspect debris was inside the new parts and fucked up my solenoid.

[@MsProjectblue]

Use o rings on the engine

[@alexanderestk]

@@MsProjectblue I replaced all of my orings and sprayed compressed air in the solenoid and it’s all good now.

[@титанбравла]

Can you tell me how to twist the balloon correctly? Do I need to relieve the pressure somehow?

[@austinleiken6210]

Will it fit on a stock base wolverine mtw m4

[@RainFrogz]

It leaks air?

[@Havoc_Aljay]

Any suggestions if the grip line is leaking

[@shafrillmj]

where can I buy the body or receiver?

[@kaslab]

🤟

[@ЧЕРВОНЧИК-у9о]

3d seriously how tired of 3d junk that breaks from sneezing

[@cbradle4]

It's molded out of the same material as many AR grips are made out of, not 3d printed. Hopefully you'll get to experience one, might surprise you.

[@r.in.shibuya]

You gotta pull some fancy mental gymnastics if you believe that looks cool.

[@TacticalShiba]

It's more of a performance upgrade rather than looks tbf.

[@TardSoftQB]

Way more comfy to carry in tournaments then a normal stock

[@bigdraco151]

nobody asked fir ur negativity