"High Voltage Showdown: Bestarc Plasma Cutters - Amps vs. Cost"

[@rocketsurgeon1746]

great vids. appreciate your time

[@petestools]

no worries

[@lmnop463]

what size compressor is needed for the 50 amp? thx🎉

[@petestools]

100 lpm

[@bearupfarm1818]

Hi, Pete the link for the 650DP 7 gen. Does not come up. Only 500DP.

[@petestools]

might be out of stock will ask them.

[@jimschaffroth5652]

I just got the 65 amp gen 7 today. Hope its better then the 50. It was considerably more.

[@petestools]

How did it work out?

[@petestools]

Hi Guys You Can Checkout The Machines For Yourself Here 65 AMP Machine : amzn.to/3rtknfY , 50 Amp machine : amzn.to/3F7gj81

[@alfredocuomo1546]

It's really going to come down to what is the largest material you are going to be using, in a DIY shop where you don't have a hoist to lift steel than the 50a will most likely be fine but if you're in a Business environment then go for the 65a. But usually after 5/8" you would get a better cut with your Oxyacetylene cutting torch.

[@petestools]

3 phase 200 amp will blow a cutting torch out of the water

[@alfredocuomo1546]

@@petestools two thing, first how many people have that when the usual is a 25 to 50 amp 220v and second the Plasma cutters will usually leave a back cut of about 15 degrees where as the torch will cut at a 90 on the thicker material. Though the Plasma cutter has the advantage of more centralized heat. They both have their places. Remember if every problem looks like a nail ever tool looks like a hammer. LMFIAO