Very good video. explains very well the complicated gear cleaning and assembly. Thank you!
@nadirhussein38714 жыл бұрын
Nice work .. for great drill .. I have the same model I also cleaned and re greasing ... it is comming like new .. I also converted the 12v battery into 14.4v Li -ion (4 cells) and now I have very strong drill running smoothly .
@mypio28573 жыл бұрын
thanks, i kept 12v with conversiona li-ion
@bisbi75233 жыл бұрын
good!!!!!!!!!!!!
@edwinoilano79925 ай бұрын
Sir ihave a problem about my drill same drill the problem battery the battery not working I buy battery where is your location, thank you sir plz reply sir
@jatindersingh5394 Жыл бұрын
which spray you used for cleaning ?
@alejandroantoniotavarezpeg44283 жыл бұрын
Hello again, help me to know which is the positive terminal of the two plates where the battery fits. Thank you, I will use it with a source because I have no battery.
@mypio28573 жыл бұрын
Hello, the positive is on the left side of the drill
@alejandroantoniotavarezpeg44283 жыл бұрын
Greetings friend I need to know which of the two is positive I bought a drill of those without battery and I want to test it with a power source. Thank you.
@gatlinidris36083 жыл бұрын
Pro tip : watch series on flixzone. Me and my gf have been using them for watching lots of of movies during the lockdown.
@jamiematthias26203 жыл бұрын
@Gatlin Idris Yea, I've been using flixzone for since december myself :)
@crewriver79563 жыл бұрын
@Gatlin Idris definitely, I've been using flixzone for since november myself =)
@عليالرسام-ي7ط2 жыл бұрын
Hello my friend, how can I convert this cordless drill from A**** to lithium, is it successful if I convert it to lithium?
@raoufchikhi8950 Жыл бұрын
How to change a drinker
@عليالرسام-ي7ط2 жыл бұрын
My friend, I hope I hope the response Is it successful?
@ENDRINAJEBACICA214 жыл бұрын
no no you have to open gear box and put new grease in it you are doing it wrong al moisture is going to motor now hell no
@mypio28573 жыл бұрын
ok thanks for the advice
@woodenheart34943 ай бұрын
I should do some maintenance.. can you tell me what went wrong? so that I don't risk ruining my drill