HM6116 2K x 8 Static RAM

[@pdpate3]

Nice job. Great easy to follow video. Thanks so much.

[@mnavarrotube]

Great video experiment. Thanks

[@NetworkXIII]

Thanks, I’m glad you enjoyed it.

[@johnbullpit9481]

Bluetac a battery on top with a diode and a resistor. I seem to remember a similar set up so that you could remove the chip with the data still stored.

[@NetworkXIII]

That sounds like it would work, thank you for the suggestion.

[@mad_circuits]

Great video, have you tried to omit the buffer? The output current possible to source/sink should be sufficient to drive the LEDs directly. Especially if you use 1.5k as resistors (about 2mA if LED_fVol is 2.5V).

[@NetworkXIII]

I don’t remember now, but I probably used the buffer to drive the LEDs because I was also using the data lines for inputs.

[@q12x]

very nice !

[@TECK2024]

Faz um video ensinando a usar o CI ATJ2259c

[@kryptocat4240]

Does thise static ram need any kind of programming

[@NetworkXIII]

KRYPTONITE TEC no, it will store whatever you load into it.

[@kryptocat4240]

@@NetworkXIII how much voltage you applied for sram

[@NetworkXIII]

I believe it was 5 volts

[@kryptocat4240]

@@NetworkXIII can you make a video on 28C16 EEPROM please please

[@kryptocat4240]

Does thise static ram need any kind of programming

[@tonymac96]

Nop...you just put data into it ...or extract data from it. As he said...be extra careful with the output enable pin ...to avoid a potential data bus crash.