Hobbywing 200 amp ESC V4.1 and V Control Setup: Part 1 of 2

[@MYHobbyPassion]

Perfect! The first and only video that shows how to learn the throttle endpoints!! THANK YOU for that!

[@rchelicopter]

Thanks Greg, just what I was looking for.

[@biscaolena]

my pleasure sir thank you

[@kyles6466]

Hey Greg, did you ever do a 2 of 2 video on this subject to finish everything?

[@biscaolena]

kzbin.info/www/bejne/majMd4Nph9aog8Usi=9Kex6Fg5JsvoE9n8

[@biscaolena]

Yes... I added the link to the 2nd video above.

[@tonychang6739]

Hi Greg, awesome learning videos. do you have a video on how to load hobbywing esc telemetry on to the vcontrol touch? thanks

[@biscaolena]

I am pretty sure my videos show that but you basically need the HW telemetry cable which plugs into the telemetry port of the Neo and the ESC. It automatically starts to read the telemetry.

[@airman9820]

Thanks so much! One question on my old vbar control it announced my battery every 10 percent so far I've yet to figure out how to do that on my touch.

[@mattdbot]

Great video Greg.. Question, I had the wrong pole count in my Vtouch/Hobbywing when I did the negative/positive pitch setting and the when I did the 50% spool up… corrected it afterwards but do I need to redo that with the correct pole count?

[@biscaolena]

I don't think so. I think the info saved into the radio merely helps with the displayed RPM. I will research.

[@mattdbot]

Thank you and please let me know

[@mattdbot]

Any info?

[@mattdbot]

Thank you for all of your helpful videos! Any info as to what I would need to do?

[@biscaolena]

@@mattdbot I did some asking and I dont think you need to redo that 50% setting. I think the pole count is merely for RPM output. I can try that this weekend myself on my 420 and see how it works. I will report back on my test.

[@michaelbehr4876]

Can you also programm the ESC without a programmer. So with beeping and remote control? is there a solution like blheli

[@biscaolena]

If you run a radio that is integrated with the ESC yes. If not then you would need to purchase a programming box.

[@victorfuentes2358]

thank you...that help me a lot ..

[@biscaolena]

awesome thank you and happy flying sir

[@NitroClouds]

What lower side frames are those? Thanks

[@adambodrogi9772]

If i did the calibration but i need to change the pinion bigger after i need to do calibration again or it's enough to overwrite the gear ratio?

[@biscaolena]

The calibration teaches the ESC the end points on the output commend from the radio to the ESC. You should be able to just change the pinion.

[@adambodrogi9772]

@@biscaolena Okay! Thank you so much🤗

[@JB6seven1]

would this be the same setup for the HW 150a v5?

[@biscaolena]

yes I have a video show my 150.

[@edgardojagr216]

We're can I get that radio

[@biscaolena]

Mikado USA but right now they are out of stock. But keep an eye open for when they get back in stock.

[@MYHobbyPassion]

Perfect! The first and only video that shows how to learn the throttle endpoints!! THANK YOU for that!

[@biscaolena]

My pleasure sir. I am glad my videos are helpful.