Tap to unmute

Hobbywing cappack for esc fitting guide.

  Рет қаралды 12,075

WTF RC Cars

WTF RC Cars

Күн бұрын

Пікірлер: 49
@louiecarias8685
@louiecarias8685 4 ай бұрын
This cappack can use any esc like rc boat shark esc???
@WTFRCCars
@WTFRCCars 4 ай бұрын
Yeh doesn't matter what esc
@SqueakLP
@SqueakLP 2 жыл бұрын
Does it need to be soldered to the actual connector on th esc or can I solder it onto the solder that's on the cable if that makes sense
@WTFRCCars
@WTFRCCars 2 жыл бұрын
It needs to be as close to the ESC as possible to work correctly :)
@stephharney8964
@stephharney8964 2 жыл бұрын
Hey there, I have a question, I have a quicrun 120 and the capacitors look to be kinda burnt, ESC still works, I only bench tested it but should I replace them or just add some more? 🤔 thank u for ur video
@WTFRCCars
@WTFRCCars 2 жыл бұрын
Better to replace them cos if they go dead short it will short out you lipos
@stephharney8964
@stephharney8964 2 жыл бұрын
@@WTFRCCars thank u so much
@stephharney8964
@stephharney8964 2 жыл бұрын
@@WTFRCCars One more thing please and thank u, would these be a good replacement for the stock ones?
@WTFRCCars
@WTFRCCars 2 жыл бұрын
Depends on the esc you have
@stephharney8964
@stephharney8964 Жыл бұрын
@@WTFRCCars its a hobbywing 10bl120 quicrun
@1manrcvids286
@1manrcvids286 3 жыл бұрын
Can I solder the cap pack near where the connector is? Or does it need to be down on the esc?
@WTFRCCars
@WTFRCCars 3 жыл бұрын
The closer to the ESC the better it will work :)
@1manrcvids286
@1manrcvids286 3 жыл бұрын
@@WTFRCCars thank you!
@WTFRCCars
@WTFRCCars 3 жыл бұрын
No probs
@evanwhittaker5287
@evanwhittaker5287 2 жыл бұрын
Do I need to use the cappack for general bashing?
@WTFRCCars
@WTFRCCars 2 жыл бұрын
Depends on the motor and ESC but they help the life of the ESC on all rc's :)
@imnoexpertrc1054
@imnoexpertrc1054 3 жыл бұрын
Did u see any changes in temp using these or ? Had to sub great vid
@WTFRCCars
@WTFRCCars 3 жыл бұрын
So the main reason to use them is to remove the very slight ripple effect you get from the pulse from the motor that get worse the higher speed the motor spins, this ripple will make the ESC work harder to level the voltage it's outputting to the motor so running them will drop the temp of the ESC slightly and also the stock caps on the ESC will run cooler hope that helps :)
@imnoexpertrc1054
@imnoexpertrc1054 3 жыл бұрын
@@WTFRCCars that’s pretty much the best explanation. Great info. I work escs pretty hard and was thinking about it just as a esc aid to help it do just what you said. Finalising my next install. Thanks man
@WTFRCCars
@WTFRCCars 3 жыл бұрын
Yeh will work great for you :)
@mohamadfauzery
@mohamadfauzery 3 жыл бұрын
Hye sir..i want ask u..If in the esc got the cap pack..so can just solder new one without remove the stock cap pack in the esc???
@WTFRCCars
@WTFRCCars 3 жыл бұрын
Yes they are designed to work with the stock cap packs :)
@mohamadfauzery
@mohamadfauzery 3 жыл бұрын
@@WTFRCCars but in the cappacitor have a different voltage n cappacity..if in stock esc have lower capacitor n voltage,then the new one more higher then stock..its still can use together??
@WTFRCCars
@WTFRCCars 3 жыл бұрын
Yes it doesn't make any difference at all :)
@mohamadfauzery
@mohamadfauzery 3 жыл бұрын
@@WTFRCCars ok2..tq sir..nice info..can try use the capacitor..
@ΚωνσταντίνοςΒασιλόπουλος-ι7ν
@ΚωνσταντίνοςΒασιλόπουλος-ι7ν 3 жыл бұрын
So u just solder them to those two wires ?
@WTFRCCars
@WTFRCCars 3 жыл бұрын
Yes just solder + and - to the esc
@ΚωνσταντίνοςΒασιλόπουλος-ι7ν
@ΚωνσταντίνοςΒασιλόπουλος-ι7ν 3 жыл бұрын
@@WTFRCCars great easy 👌 how u seen the esc so far ? Are u running 6s ? Do u seen any difference with that capacity pack?
@WTFRCCars
@WTFRCCars 3 жыл бұрын
Yes I'm running 6s, you won't see any difference running a cap pack, the cap packs do nothing at all for performance they remove the voltage ripple giving the esc an easier time and will increase the life you get from the esc especially if your doing high speed runs
@ΚωνσταντίνοςΒασιλόπουλος-ι7ν
@ΚωνσταντίνοςΒασιλόπουλος-ι7ν 3 жыл бұрын
@@WTFRCCars I having hard time with the esc fan because it is easy blocked from things come inside and stopping it ..do u have any opinion on that do u have faced something like that ?
@WTFRCCars
@WTFRCCars 3 жыл бұрын
For the esc fans just put some fine mesh over the fan it's the only way I found to stop things jamming them up :)
@rilmalacca461
@rilmalacca461 3 жыл бұрын
hello sir..this cap pack can used any esc?
@WTFRCCars
@WTFRCCars 3 жыл бұрын
Yes so long as the esc is not running any higher than 6s, if you are running more than 6s you will need a pack that can handle the higher voltage I believe.
@JesseBlum
@JesseBlum 9 ай бұрын
How mnay volts is yours?
@WTFRCCars
@WTFRCCars 9 ай бұрын
I run these on my kraton 6s
@cwatson42785
@cwatson42785 2 жыл бұрын
Do you know what cap pack i would need for a max5 esc?? My dbxle is cutting out and esc is flashing when I go under full power. Think it's because I need a cap pack? Thanks
@WTFRCCars
@WTFRCCars 2 жыл бұрын
I'd say you lipos are not strong enough for the motor/ESC or you have far too big pinion so the ESC is cutting out cap packs won't help this, cap pack are only to help level the voltage if you getting a complete cut out then you have other issues :)
@cwatson42785
@cwatson42785 2 жыл бұрын
@WTF RC Cars Ah ok, I'm using Zeee premium 9200mah 120c 4s lipos, they were expensive lipos and i know sone people either love or hate Zeee lipos but I've never had a issue with the normal zeee packs and the premium ones run 8s no problem in my super rock rey. I'm using a stock 18t pinion. I think the pinion might be too big as my dbxl has alot of the aluminum hop ups on it and is incredibly heavy. It's probably almost 50lbs after the upgrades. It speed tested at 55mph so with a rig that big and heavy I think gearing down definitely won't hurt that's for sure. I'll try that next. Maybe go to a 15t or even 14t. Thanks for the advice! Maybe I'll throw a cap pack on it just to be safe as I don't know why such a powerful system didn't have one stock. Its odd as its almost going into limp mode or lvc to protect the motor. Thanks bud
@WTFRCCars
@WTFRCCars 2 жыл бұрын
Yeh I'd have a good look at the set up as you may be hitting the max amp draw of the ESC and so it going into protect mode :) the zeee packs should be fine I actually use zeee packs in race rc's and don't get any issues :) but yeh a cap pack won't ever hurt and will give the ESC an easier time :)
@owen8538
@owen8538 11 ай бұрын
Is that good for 2- 3 s
@WTFRCCars
@WTFRCCars 11 ай бұрын
It should work for 2 - 3s yeh but this one is for 4 - 6s esc
@Retrograde99
@Retrograde99 2 жыл бұрын
Why don't they put it on standard or make it so you can just plug em in somewhere :/
@WTFRCCars
@WTFRCCars 2 жыл бұрын
Just because you don't have to use em and you can get bigger ones depending on how your running the ESC :)
@Retrograde99
@Retrograde99 2 жыл бұрын
@@WTFRCCars so it’s not that useful?
@WTFRCCars
@WTFRCCars 2 жыл бұрын
They will give you longer life from your ESC so definitely worth fitting them
Hobbywing CAPACITOR MODULE-NON POLARITY-STOCK HW30840004
8:26
WTF RC Cars
Рет қаралды 2 М.
Ep. 193: Cap Pack Considerations
14:41
rhouse21 - RC Physics
Рет қаралды 10 М.
Quando A Diferença De Altura É Muito Grande 😲😂
00:12
Mari Maria
Рет қаралды 45 МЛН
黑天使只对C罗有感觉#short #angel #clown
00:39
Super Beauty team
Рет қаралды 36 МЛН
Try this prank with your friends 😂 @karina-kola
00:18
Andrey Grechka
Рет қаралды 9 МЛН
Why use a Cap Pack on an RC Car? (Capacitor Pack)
7:15
RCexplained
Рет қаралды 38 М.
Hobbywing max8 esc upgrade in traxxas maxx
11:57
mad on rc
Рет қаралды 21 М.
Installing a capacitor pack 1/8 esc
2:54
Mikes Man cave
Рет қаралды 3,6 М.
The Charlie Show /// Episode 234 /// Power Cap Installation Tips
8:10
HOBBYWING Official
Рет қаралды 10 М.
Tamiya car prep and Hobbywing brushed  ESC upgrades
12:17
Popalong RC
Рет қаралды 8 М.
How to make a Glitch Buster for RC
5:46
YellowBonz69
Рет қаралды 54 М.
EC5 battery connector soldering Action ! 🔥 👨‍🏭
6:39
Andy’stoybox17
Рет қаралды 9 М.